Ariens
It turns over but it won’t catch.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A common issue is a clogged carburetor from stale gas. Using a fuel stabilizer keeps fuel fresh and the carburetor from gumming and varnishing. Third step, check the ignition system with a spark tester. Step four, replace the spark plug and reconnect the spark plug wire.
If your snowblower won`t turn on or start, you can insert the key in the starter switch. There could be a problem with your starter switch or motor. To test the starter switch, you can use a multimeter. If the starter switch is not working properly, replace it.
Since your snow blower has sat idle for months, the gas could easily have developed gummy residue, which can make starting the machine difficult. Siphon out the old stuff with a small siphon pump, and follow these steps for how to dispose of the gasoline. Then, fill the tank with fresh gas and try starting it again.
The most common culprit of a hard-starting engine is stale fuel. If you left fuel in the tank over the summer, it`s best to drain it by accessing the fuel line or using a siphon system.
If your blower is having a difficult time starting, then you may be dealing with a carburetor issue. The carburetor`s job is to ensure the proper mix of fuel and air is directed to the blower`s engine. As mentioned, the carburetor can become clogged, making it difficult for fuel and air to enter the engine.
Fuel Shutoff Valve
If it`s been sitting for a while, now`s also a good time to drain the gas tank and refill it with some fresh fuel. Turn the fuel shutoff valve to the open/on position to start the engine, and leave it open until you`re done.
A clogged carburetor is usually the result of leaving fuel in your snow blower for an extended period of time. Old fuel resting in your snow blower can also result in fuel evaporation, which may leave behind a thick, sticky substance. That sticky fuel can clog the carburetor and prevent the engine from starting.
Check the fuel or spark plugs—each is fairly simple to do. First, drain the fuel from the tank and refill it with fresh gas. Next, try replacing the spark plug by disconnecting the rubber boot attached to the plug and removing the plug with a ratchet wrench.
The most common culprit of a hard-starting engine is stale fuel. If you left fuel in the tank over the summer, it`s best to drain it by accessing the fuel line or using a siphon system.
A snowblower that won`t start after summer storage likely suffers from fuel system contamination. Draining the fuel system and refueling usually solves the issue, however, a carburetor cleaning may also be required.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
ANSWER : Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only
Read Full Q/A … : Ariens
Toro clear won't start – Toro Power Clear 621 R
ANSWER : Bad gas , plug ,air filter , no spark ck all need all 3 to start
Read Full Q/A … : Ariens
Mower won’t start
ANSWER : This may sound stupid but don’t mean it to…
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Hope it helps.
Anthony
Read Full Q/A … : Ariens
My mower will start but won't stay running – Toro LX466 22HP Lawn Tractor 13RT61RH244
ANSWER : I am going to respond 2 times to this post. The first reply will be generic things to check.
First off check the oil level and make sure it is serviced to full.
If your having a lack of fuel (runing lean) you will need to check fuel flow at the carb fuel mainfold. It should fill a spray paint can lid in less than 10 seconds but teting flow rated of the main fuel line. If you have poor flow here… you need to check the fuel filter and the fuel tank outlet port for obstructions.
First off check the oil level and make sure it is serviced to full.
If your having a lack of fuel (runing lean) you will need to check fuel flow at the carb fuel mainfold. It should fill a spray paint can lid in less than 10 seconds but teting flow rated of the main fuel line. If you have poor flow here… you need to check the fuel filter and the fuel tank outlet port for obstructions.
Good Fuel flow still shutting off…. remove the carb float bow and clean the debris from the bow’ and the treaded area where the fuel solenoid mounts Additionally you will have to again remove the main fuel line and spray carb cleaner in the float needle area to flush out any debris through the fuel hose connection.
For the second response I need to know which engine is installed on your mower by MODEL number if you can locate it. (there are 3 engines) At least try to find the engine model number. If you can not locate it Brand and HP of the engine (I assume 22 hp) Thanks for choosing FixYa,
Kelly
Read Full Q/A … : Ariens
Won't start – Echo Pb – 413t Backpack Blower
ANSWER : Adjust the carb,altitude can effect the engine
Read Full Q/A … : Ariens
Have a john deere sabre turn key won’t start thought battery was dead charged battery still won’t start jump start with car battery it will start then . try to engage reverse with blades running it shuts off. shut down tractor won’t start again .I,m thinking wiring not grounded but where or replacement switch somewhere.give best advise.
ANSWER : Some mowers have a mowing reverse safety switch. That safety will kill the mower if you try to reverse with the deck engaged. Some mowers even have an override button that has to be held while backing up. As for the battery thing, no matter how much you charge a bad battery you will not get it to start a mower if it has a bad cell or two. I would use a multimeter to check battery voltage, but the end result would still be the same, replace the battery.I hope this gets you going again.
Read Full Q/A … : Ariens
My lawn mower won't start – Brute 7800802 22-Inch 190cc Briggs & Stratton 675 Series Gas Powered FWD Self Propelled Lawn Mower With High Rear Wheels
ANSWER : Your carb is jammed up with ethonal eithier clean t out or replace the carb and run non oxy fuel from now on and u won’t ever have any issues AGIAN
Read Full Q/A … : Ariens
While trying to start the saw the compression is so great that it is near imposible to pull the start rope ….ie won’t spin fast enough to start … new plug ,,,, new gas …..no start ,,,tired arm ,??????
ANSWER : Is there a compression release button?
Read Full Q/A … : Ariens
