16 In 4.5 Hp Electric Chainsaw With Carrying Case MCC4516FK

Experienced gardeners share their insights in answering this question :
There is certainly an amount of work to do, the starter cover, the left hand side cover complete, the anti vib springs, the fuel hoses, the tank then pulls out from the left hand side of the saw once these components are removed.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Cutting down large, living trees

To cut down or cut this, we recommend to use a gasoline or electric chainsaw with a power of more than 2,000 watts. You`re going to need this with large trees, since the deeper you`re sawing, the harder the trunk is to cut down.

Selecting the Right Electric Chainsaw

A mid-duty model is likely to cost about $250, and an inexpensive one suitable to handle the occasional downed tree limb is going to run you roughly $150 to $200. Also, an inexpensive electric chainsaw is not going to churn through a pickup truck`s worth of firewood in a morning.

Fuel tank capacity: 0.59l.
Power to weight ratio: Calculated by dividing a chainsaw`s power (hp or kw) by its weight (lbs or kg). Typical calculations use the dry weight (no gas or bar oil) of just the chainsaw`s powerhead and exclude the weight of the bar and chain as they are generally a constant when comparing similar models.
Electric chainsaws are best used for sprucing up trees, trimming limbs, cutting small logs, and other cutting tasks around your home or yard.
For example, some electric chainsaws have power heads that operate at speeds of 6600 RPM and generate as much power as a 40cc gas engine.
The ideal chainsaw size for a homeowner of course depends on what that homeowner will be using the chainsaw for. Most homeowners would benefit from a chainsaw between 14″ and 20″, depending on the most common types of projects they have on their property.
Most modern chainsaws, string trimmers, leaf blowers and other small-engine two-stroke equipment recommend a 50:1 oil mix ratio, but some recommend 40:1 and older two-stroke equipment might even call for 32:1.
Although electric chainsaws are smaller and easier to carry, most lack the power and stamina to cut down large trees. If you have big trees on your property that you want to remove or cut into firewood, a gas model is your best bet.
Overview of Electric Chainsaws

Electric chainsaws produce significantly less power than their gas counterparts, which often makes them easier to handle and causes less strain on the user. Additionally, electric chainsaws are relatively low maintenance because they don`t require oil changes or spark plug adjustments.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a husqvarna 323L string trimmer. I stored it after running the tank & carb dry for about two years. I fueled it, then started it, & it ran for a minute then died like I turned the switch off. Since it would not restart, I found the fuel filter had broken off the hardened fuel line & it sucked gummy crap out of the tank & into the carb. Failing at cleaning the carb, I finally put a new carb on it & replaced the pump, hoses & filter. It has ran good till this year. I winterized it with stabilizer & left it with a full tank over the winter. The gas in the tank was gone when I got ready to use it this year. I filled the tank with premix, checked for leaks, then started it. It would run fine for about half a tank, start idling poorly (lean) then cutoff & refuse to restart till I refilled the tank. I finally found the tank had cracks & was letting pressure out of the tank & apparently this was causing the carb to lose it’s ability to siphon gas out of the tank. So I replaced the tank which came with new hoses & a filter, which I properly installed to the carb. It cranked right up, but when it runs a half tank, the carb quits sucking gas out of the tank. When I pump to prime the carb, it moves the fuel into the carb, but the pump never gets hard like it does when I prime the carb when the motor is cold. I have to keep refilling the tank, prime, & then it starts & runs until the tank gets about half empty. The new fuel filter is down in the gas tank properly, but It will not run after it shuts off until I refill the tank & prime. I’m baffled. New tank, new hoses, new filter, new carb, & I can find no leaks in the fuel system. It runs strong. The 323L is a two-stroke & it always cranks on the second pull from cold on a full tank. Any ideas?

I know this is a pretty old thread. But I have a 2004 Husqvarna 359 and it does the same thing. Has anyone found the cause of the problem yet. It seems to die from lack of fuel or too lean of a mixture only when the saw is hot. I have : removed the cylinder and found it to be scored very bad, i replaced the cylinder and piston, replaced the fuel filter, removed the carb and checked for debris, new spark plug, new air filter, changed fuel to a 32:1 just to see, all to no avail. I dont know how to test the ignition module, and I dont know if there is a way to test the cranck shaft seals. If any one can give me advise from here it would be greatly appreciated. Thank You, Brian in Spokane Wa.
ANSWER : I didn’t want to close the thread in case someone else had some ideas. We can still discuss this problem. Enter any clarification or additional information below the advertisements. HTH
Lou
Hoped Dolf would chime in.

1999 ford expiodition
ANSWER : Use a pressure gauge to check pressure at the rail. Change fuel filter. Replace fuel pump if needed.

Need to replace fuel lines on my Troy Bilt gas hedge trimmer. Where can I get replacement fuel lines… or better yet… what size are the lines and where can I buy a few feet of the lines. Note: I have reviewed the parts assembly and it would seem to indicate I have to replace the entire handle assembly (Part #1) instead of just buying replacement hose(s). Any help to resolve my issue would be greatly appreciated and thanks in advance
ANSWER : Replacement fuel lines should be readily available at your local lawnmower repair shop. Your TroyBilt hedger uses fuel line that is 3/32″ (2.4mm) interior dimension, 3/16″ (4.8mm) outside dimension, with a 3/64″ (1.2mm) wall dimension.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.

Make sure to clean the in-tank filter when replacing hoses.

Good luck.

Have a craftsman 16″ chain saw 358.360260. Could not initially get it started after it had sat for a couple years with fuel stabilizer in it. When I went to use it the fuel had all evaporated and the fuel pick line was rotted. I replaced that with some difficulty but finally got it on. Saw still wouldn’t start. Replaced the fuel filter. Still wouldn’t start. Pulled the carb apart and cleaned and recleaned everything. Diaphragms were good and I didn’t adjust any of the mixture screws because as I said it ran fine before storage. Non of the carb passages were clogged. Fresh gas 40:1, good spark plug and good spark. Airfilter is good. Engine has maybe about 4 hours of total run time on it. It’s a ZAMA (?) carb. It will run for about 30 seconds when I manually prime it by pouring a small amount of fuel directly though the carb. When I was disassembling the carb the vent hose that goes back into the fuel tank seemed to have a small out of ?substance? in it which I cleaned out. It was right at the end the of the hose that goes back into the fuel tank and not up by the carb. It didn’t appear to be like your typical gummy deposits/varnish though. I hope it wasn?t some type of spongy check valve stuff that is supposed to be in there. That might explain some of my problems. Anyway, I also can not seem to get the primer bulb to fill. When I open the fuel tank, look in side and depress the primer bulb, air bubbles come out of the fuel filter. But when I let the bulb reexpand there’s no fuel that gets sucked up the hose. I can however seem to fill the primer bulb when the fuel tank is full and the chainsaw is laying on it?s pull cord side and the bulb is depressed a bunch of times. The saw will also start and run again for about 15 seconds then die. It’s definitely not getting/fuel and probably running out . Thanks.

The fuel lines have rotted out of the edger gas tank. How do I fix or do I need to replace entire tank with new fuel lines?Since there are no male fuel line connections exiting the fuel tank and just two holes where the lines were, I guess I need to replace the entire tank and get a new one with lines already attached. Thanks.
ANSWER : No you can buy replacement fuel line but you must reconnect the filter in the tank that line goes to the bottom of the carby then out the top of the carby to the inlet on the primer then out of the primer and back to the tank.

Fuel lione and filter came off in the tank – Stihl HT101 Pole pruner
ANSWER : This is a simple repair.
1. Drain tank save fuel can be used again
2.Purchase fuel line replacement kit Lowes -Home Depot
3.Kit needs to contain feed wire and gas hose.
4.Disassemble cover to reveal fuel line connection to carb.
5. Feed wire from kit into fuel tank through fuel line hole.
6. Install new hose over wire connecting end into hook at end of wire
7. Pull hose through tank up to the carburetor
8. Remove wire and connect filter and hose to carburetor
9. Replace gas into tank, Ck for leaks

2005 toyota carola fuel gauge is showing empty tank all the time
ANSWER : Fill tank OR check wireing connections or replace sending unit.