Cub Cadet
Mower makes a clicking sound like the battery is dead, replaced the battery and does the same thing
Experienced gardeners share their insights in answering this question :
Check the motor turns by hand,spin the disc where the blades bolt on ,check for oil,sounds as if it’s seized.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and prevent the engine from starting.
If your lawnmower is starting and then stalling, the most likely issue is the carburetor. The most common issue is that the carburetor is dirty. Here`s what you need to know about how a dirty carburetor can cause a lawnmower to start, then stall out and die.
If the engine will not crank, you likely have a problem with… Discharged / defective battery or faulty electrical connections. To address these issues, check the battery and charging system for problems. Faulty parts: potentially the safety interlocks, starter motor switch (open circuit) or solenoid.
A dirty carburetor is one of the most common causes for a lawn mower not being able to start after sitting unused for months or years at a time.
Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. For small engines, spark plugs typically need to be replaced every season or after 25 hours of use. You should also check to make sure the spark plug gap is set correctly.
Use Carburetor Cleaner
Fortunately, you can generally do this without even taking the carburetor out of the engine. Start by purchasing some commercial lawnmower carburetor cleanerOpens a new window, which comes in a simple spray can and will make it easy to clean the inside and outside of the carb.
An airlock is one of the common causes why your mower won`t start after running out of fuel. An Airlock occurs when air replaces fuel in the fuel lines. As you refill your fuel tank, you could push the air towards your mower`s carburetor, which keeps the new fuel from reaching the engine.
The clicking noise comes from a part called the starter solenoid. The solenoid connects the battery to the starter motor when the solenoid is energized. The key switch and the safety switches in the starter circuit combine to energize the solenoid. If the solenoid is clicking, the circuit that triggers it is working.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
The lawnmower won t start after pulling the start up cord . changed the spark plug it still won t start
ANSWER : Try a touch of starting fluid right into the carburator by taking the air filter off. If it then starts but wont run or stay running, the reservoir below the carb should be removed to clean at and the pinhole in the intake tube above the bowl nut. This is the most common problem with lawnmower start problems, the pinhole can be unplugged with one wire from a wire brush. Be careful with the gas, at least pinch off the gas hose with a vise grips while removing the carb bowl.. Never use a droplight around gasoline.
Read Full Q/A … : Cub Cadet
Ride on lawnmower lr35 just clicking and wont start
ANSWER : Check battery and starter cables for tightness and corrosion. also battery voltage.
Read Full Q/A … : Cub Cadet
Lawnmower starts and dies… where is the main jet for the carb?
ANSWER : Try
cleaning the air filter, then a touch of starting fluid right into the carburator by taking the air
filter off. If it then starts but wont run or stay running, the
reservoir below the carb should be removed to clean at and the pinhole
in the intake tube above the bowl nut. This is the most common problem
with lawnmower start problems, the pinhole can be unplugged with one
wire from a wire brush. Be careful with the gas, at least pinch off the
gas hose with a vise grips while removing the carb bowl.. Never use a
droplight around gasoline. most lawnmowers have no mixture adjustments, so it is a matter of cleaning the carb, tank, gas lines. Some oils in gas mix systems settle and clog after less than one season.
cleaning the air filter, then a touch of starting fluid right into the carburator by taking the air
filter off. If it then starts but wont run or stay running, the
reservoir below the carb should be removed to clean at and the pinhole
in the intake tube above the bowl nut. This is the most common problem
with lawnmower start problems, the pinhole can be unplugged with one
wire from a wire brush. Be careful with the gas, at least pinch off the
gas hose with a vise grips while removing the carb bowl.. Never use a
droplight around gasoline. most lawnmowers have no mixture adjustments, so it is a matter of cleaning the carb, tank, gas lines. Some oils in gas mix systems settle and clog after less than one season.
Read Full Q/A … : Cub Cadet
Help with the lawnmower. It starts and stalls after a few seconds
ANSWER : Check the fuel system clean the carb .
Read Full Q/A … : Cub Cadet
How to take off carbarator – Briggs & Stratton Briggs Stratton Lawnmower Lawn Mower Short Block
ANSWER : Usually there are two screws. On some newer mowers the same screws hold on the Air Cleaner housing.
Read Full Q/A … : Cub Cadet
Ryobi problems cogs of the wheel wont engage, so trimmer teeth dont move.
the worm drive needs to be adjusted some how. how?
the worm drive needs to be adjusted some how. how?
ANSWER : Sorry not to have better news. The plastic housing on that trimmer is not strong enough to support the drive gears. Ryobi has discontinued that model.
I have had mine apart several times. The housing for the gear cogs is plastic and flexes. I’ve tried to reinforce it and added spacers between the plastic housing and the bearings that support the drive shafts in attempt to force the teeth together. But the trick only lasts for a few minutes. As soon as I start to cut with it, it stops again. It’s just not worth the time, effort and frustration to continue working on it just to have it stop working again.
I finally discarded the Ryobi unit and purchased one with a metal (aluminum) housing. I think it is a Poulan Pro model from Walmart. It has worked well.
Read Full Q/A … : Cub Cadet
Sthl chain saw ground wire came loose
ANSWER : This might be some help. I dont quite know what you’re asking. If you know the problem then just replace it.
Read Full Q/A … : Cub Cadet
Lawn mower ran out of gas, after refilling it will start, run for a few seconds and cuts off. There is no primer button for this model.
ANSWER : It would be best to take this machine into a dealer like www.arcolawn.com and have the thermostat checked out. There were some early autochoke thermostats that would stick and cause problems.Best wishesJoewww.barter-joes.com
Read Full Q/A … : Cub Cadet
