Garden
Won't raise mower deck
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Mow Your lawn like a pro, with the smooth, effortless performance of the Kommander. Introducing the ALL-NEW Kommander with 42” deck. The K-Lift pedal makes adjusting the cutting height simple.
For most effective results, a lawn mower deck should have a pitch, or height difference of 1/8-inch to 1/2-inch between the front of the deck to the back of the deck. Naturally, this makes the sweet spot about 1/4-inch of pitch, depending on the mower model.
Turn the adjusting lock nut clockwise to raise the mower and counterclockwise to lower it. Measure from the blade to the ground again on both sides and adjust until the difference between the blade tip heights are within ⅛ -inch. Rotate the blades so that their direction is now front to back.
For most effective results, a lawn mower deck should have a pitch of 1/8-inch to 1/2-inch between the height of the deck rear to the height of the deck front.
Your Mower Won`t Start:
Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.
Walk-behinds offer several advantages over riding models, including increased operator flexibility to move obstacles out of the mowing path without getting on and off of the machine, the ability to mow in confined spaces, and increased performance in trimming applications, says Moorlag.
Turn the adjusting lock nut clockwise to raise the mower and counterclockwise to lower it. Measure from the blade to the ground again on both sides and adjust until the difference between the blade tip heights are within ⅛ -inch. Rotate the blades so that their direction is now front to back.
A high-lift mower blade is the standard mowing blade designed to cut grass and discharge the clippings out from the deck or capture them in a grass collection system.
Electronic Common Rail System (CRS) 53.0 hp @ 2600 rpm Page 2 L6060 Confidential – Kubota reserves the right to change the above specifications without notice.Kubota Confidential Page 2 Height to top of ROPS or Cab 98.0 in. 92.5 in. Overall Width (min.
Just STEP on the deck pedal, TWIST the knob to your preferred height, and CUT away with total control.
The first step to a beautiful lawn is a level mower deck. Level your mower deck once or twice a season.
Loosen the lower nut, the jam nut, on the adjustment link with a wrench, moving it clockwise to raise the front of mower, and counterclockwise to lower it. Tighten and remeasure. Repeat as necessary until the deck is adjusted properly.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I had hit a somewhat hidden stump on the lawn..bending the blade. Took the deck off and replaced the bent blade. Put the deck back on and now the cut seems uneven. It appears that the deck is now uneven. I attempted to follow the directions for a side-to-side leveling. Started with trying to measure the blade height and am struggling with getting to a spot where I can measure the blade on the left side. By looking at the deck, it appears to be uneven. I am struggling with being able to raise the left side of the deck.
ANSWER : I’ve only had luck removeing the deck, turn it upside down. Measure blade, mark, remove blade, insert large pipe over spindle, bend in direction. Re-install blade, and do it all over and over till straight. Measure in several locations.
Read Full Q/A … : Garden
Deck only raises a little bit, not the way it is supposed to. Selections 1-4 is the same level, resting on the ground. how do i fix this
ANSWER : The bolts or wing nuts for the deck adjustment have likely come loose or off entirely from the raising/ lowering undercarriage.
Once you have identified the loose or missing nuts (and replaced, making sure to add lock washers) then move the mower to a flat, level surface and move height lever to the lowest setting (some mowers have a flap over an ultra-low setting for this purpose).
Now tighten the nuts on the raising / lowering arms. You should now have normal control over the height.
Farmerbear at FixYa.com
Read Full Q/A … : Garden
Mower won’t start
ANSWER : This may sound stupid but don’t mean it to…
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Have you tried with the choke all the way open? Do you have an automatic cruise? Is the right (correct) pedal being pushed in? These will affect if it starts or not. Also if your drive belt or one of the other belts not being tight enough will affect if it starts or just turns over. Not too many things can stope it from starting with new/good battery AND if its getting gas. Try cleaning your gas line and obviously making sure there is no obstruction around or near your blade, if it does start with blade engaged that is :))
If it doesn’t start with blade engaged, well make sure it’s in neutral. Mine won’t start in reverse but will in forward or neutral.
Hope it helps.
Anthony
Read Full Q/A … : Garden
Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
ANSWER : Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only
Read Full Q/A … : Garden
Need diagram of deck belt installation – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : May I get the make and model # to get you the right belt diagram
Read Full Q/A … : Garden
How do i adjust deck belt tension – Poulan 38-Inch Steel Deck 15.5 HP Briggs & Stratton I/C Engine With 5 Speed
ANSWER : Most cases there is no adjustment to the belt if it is mounted correctly it tensions itself, if you need more adjustment you might need to just change belt because your other one is most likely stretched.
Read Full Q/A … : Garden
BX24 kubota tractor purchase new in 2007 – diesel; after turning off ignition, tractor continues to run irradically for a few minutes. It doesn’t shut off when I get up out of the seat with the brake off. I’ve cleaned all terminals on the seat and ignition. Approximately 200 hours on it. Has always been under cover. Any suggestions would be welcome. Thank you.
ANSWER : That sounds like an injector pump problem and not the switch.
Read Full Q/A … : Garden
I have a B1200 kubota tractor and want to get a manual on it
ANSWER : Call (803)-536-9411 or 800-849-9412 ask for Justin. Tell him Brad sent you
Pioneer Farm Equipment.
Brad.H
Pioneer Farm Equipment.
Brad.H
Read Full Q/A … : Garden
