Experienced gardeners share their insights in answering this question :
On some of the mowers to push it you have to pull a lever in the back that disengages the transmission. make sure it is pushed back in the operate position. also if not hydro stat . check the belt to be sure it has not came off.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If there is interference with the brake/clutch pedal, your gear shifter may not come out of the neutral position. Inspect the linkage between the clutch/brake assembly and wheels, as well. Any damage or obstructions should be repaired immediately since this also causes a safety issue.
The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
The factors that are causing your lawn mower engine to seize are the lack of lubrication, overheating issues, or having a dirty air filter. It could also be due to the lack of use, fuel-related issues, or mechanical failures taking place.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Lawn mower will start and run for 5 seconds and shut down
Will it stay running with your choke on? if so then clean your carb. if not then look for a blockage from tank to carb. ie fuel shut off, deteriorated fuel line. plugged filter etc
Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only
Lawn mower motor runs good, the drive wheels run good but the blade won’t stay enguaged. Thanks
Check your cable that controls the blade engagement.
I have trouble starting a toro walk behind mower
All, I thought my carb was shot, so I replaced it. Still, start but no run (and had to use starting fluid). THEN!!! I noticed the spring to the “rev limiter” (just below and towards rear of carb) was not “tight”. The stupid bracket that holds the end of that spring had been bent down ~1/16″ and that caused all this heartache. CHECK YOUR REV LIMITER!!!
Lawn mower cranck but wont start…
Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.
Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.
B&S Quantum Power 4hp won’t start with fresh plug,
Did it run before you changed the plug?Gap is correct, flywheel shear pin may be bad, Water in the Gas?
I have a Poulan push mower that after mowing in a ditch started making a loud noise and running rough. It almost sounded as if metal was hitting metal. The mower was vibrating more than normal. I checked under the mower and nothing is hitting. After a few times of stopping the mower engine because it sound as if it is going to die down the mower will not start now. The shaft does not appear bent and the blade appears ok. The mower has oil, a good spark plug and a clean air filter. It was running fine until that moment. I did not see anything that I hit but it is possible I hit something in the ditch like a pine cone or branch. What could the problem be and how would I go about fixing it?
If you are sure the oil level is correct then it sounds like it’s about to die, unfortunately. A pine cone shouldn’t cause any damage, but a large branch may do so. Was it smoking before you shut it down? The vibration could be caused from a bent blade. It could also be caused from a part breaking in the motor. I wish I could have given you better news!
My mower will start but won't stay running – Toro LX466 22HP Lawn Tractor 13RT61RH244
I am going to respond 2 times to this post. The first reply will be generic things to check.
First off check the oil level and make sure it is serviced to full.
If your having a lack of fuel (runing lean) you will need to check fuel flow at the carb fuel mainfold. It should fill a spray paint can lid in less than 10 seconds but teting flow rated of the main fuel line. If you have poor flow here… you need to check the fuel filter and the fuel tank outlet port for obstructions.
Good Fuel flow still shutting off…. remove the carb float bow and clean the debris from the bow’ and the treaded area where the fuel solenoid mounts Additionally you will have to again remove the main fuel line and spray carb cleaner in the float needle area to flush out any debris through the fuel hose connection.
For the second response I need to know which engine is installed on your mower by MODEL number if you can locate it. (there are 3 engines) At least try to find the engine model number. If you can not locate it Brand and HP of the engine (I assume 22 hp) Thanks for choosing FixYa,