Garden
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Check that all the safety switches are working correctly, it is possible the seat switch is bad or loose plug/ bad wire. Also if battery weak or charging system weak/faulty the clutch will stall out engine, charge battery up with charger and try.
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Top Reasons why your blades will not engage on your riding mower or tractor: Belt-the number one cause for your blades not to engage is that your belt is either stretched or loose causing it to slip or fall off completely. Belt could have snapped also.
It could be your bearings and your spindle pockets, or spindles, have seized up,” says Oshel. If the blades are stuck, pump some grease into the fitting and carefully work the blades back and forth by hand until they move freely.
If your lawnmower is starting and then stalling, the most likely issue is the carburetor. The most common issue is that the carburetor is dirty. Here`s what you need to know about how a dirty carburetor can cause a lawnmower to start, then stall out and die.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
Lack of ownership: Since PTO isn`t accrued as they work, employees don`t feel like it “belongs” to them. If they don`t feel like they`ve earned it, they don`t use it. Lack of encouragement: Managers fall into the same trap of taking less time off. This sets a bad example that their employees feel pressured to follow.
Whenever the blade is engaged, it rotates on a crankshaft to cut the grass. But if there is interference in this rotation, the engine can overload and shut off or lose power. Check the crankshaft connection to see if it rotates freely. Inspect the connecting hardware for damage or rust.
Clogged or Dirty Air Filters
It is one of the most common problems that cause lawnmowers to sputter. The mowers take the air from the surrounding through air filters and mix it with fuel inside the engine. So, if the air filter is clogged or dirty, it will affect the flow of air into the carburetor.
The possible causes of a lawn mower blade spinning but not cutting grass include a damaged or wrongly installed blade, a dull blade, or damaged lawnmower tires. Other possible reasons can be improper tire pressure, a clogged deck, or a broken mower belt.
A good rule of thumb for the average homeowner is to replace your mower blades annually. You may also think about replacing them if they become damaged. Dig up that product manual if you want a more clear-cut answer. Always make sure to take protective measures whenever sharpening your mower blades at home.
An improperly routed belt can cause the engine to die when the blades are engaged. To check belt routing, lower the deck to its lowest setting and remove the belt guard by the drive pulley. Next, lift the belt over the pulley and remove the pins that support the deck at the rear.
This is most likely a safety switch issue. Usually the seat safety switch will cause this problem. The mower dies because it thinks nobody is sitting in the seat, and shuts off for safety reasons.
(1) The blades should always be turned on at full throttle if the mower has a electric P.T.O. switch.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
John deere stx 30 pto wont engage
ANSWER : Check your fuse or for a broken wire( or shorted)
Read Full Q/A … : Garden
Need the pto to work on a 6300 john deere tractor we have changed the fuses and changed the sencer on the back can you help
ANSWER : If you have tried a new sensor and a new switch the the next step is to replace the pto solenoid valve.If that proves fruitless then the b.c.u.needs to be replaced or bypassed.The solenoid valve will cure your problem 90% of the time.If that does not work,let me know,i can tell you how to by-pass the b.c.u..
Read Full Q/A … : Garden
The mower blades on my John Deere stx 38 lawn tractor will not engage. I just installed a new pto switch and when engaged the engine stops.
ANSWER : It sounds like the safety switch under seat is bad
Read Full Q/A … : Garden
Problem starting every time when starting cold I have to crank engine several times, after it runs it will start every time until it sets for a few days, then back to the repeated cranking.
ANSWER : Thats perfectly normal
Read Full Q/A … : Garden
I have John Deere GX345. It does not start consistently. When it doesn’t start the plugs have no spark. The problem is intermittent.All electrical connections look clean and no corrosion. Re- seated all connections. Fuel flow is good because I can smell raw fuel while cranking the motor. I replaced the fuel lines last year. Thank you for your help. Daryl Witowski
ANSWER : Look for a small silver box with 1 wire on it mounted to the motor. It is a temp sensor and will keep it from firing…Just had to replace mine…
Read Full Q/A … : Garden
Weak fire out of coil wire – John Deere Pto Clutch For Stx38 And Stx46 Lawn Mowers
ANSWER : This can be due to a dirty flywheel, an improper gap between the flywheel and coil, or a coil that is failing, first check for rust or dirty build up on the flywheel, then check for proper gap, and if neither of those are the issue, replace the coil
Read Full Q/A … : Garden
My Tractor (425) won't start – John Deere 420,1020,2010,2020,2510,2520 Tractor Float
ANSWER : If you have no spark the first thing to replace the time delay module on the left rear side of engine. Its black and about 2 inches by 1 inch with yellow,red,orange and black wires going to it. Replacement is round shaped with same amount of wires.If no fuel to carb check for flow at filter, if theres flow but no pressure look for a split fuel line in tank between pump and sender.
Read Full Q/A … : Garden
I am trying to find a new or second-hand bonnet for my john deer stx38. i live in the gippsland area. any suggestions?
ANSWER : I use www.greenpartstore.com
Read Full Q/A … : Garden
