John Deere

Experienced gardeners share their insights in answering this question :
Could be a problem with you hydrostatic transmission fluid, the dealer can replace the entire transmission (this is usually the course they push) and with labor will cost around 700$.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

An air lock in the transmission can cause problems with a lawn mower`s ability to go up hills. This problem occurs when air gets trapped in the transmission, which can cause it to lose power or stop working entirely. To solve this issue, it`s necessary to check for and remove any air locks in the transmission.
When a spark plug becomes fouled, the tips become coated with fuel, carbon, oil or dirt. This interference limits the ignition power needed for mowing on level or uphill surfaces. Maintain your spark plugs by changing them every season or regularly removing and cleaning the tips.
Reasons Mowers Stall

If you have a steeply graded property, hill stalling is often a sign your mower is not strong enough to perform the task at hand. Another reason this occurs is due to problems with the engine, such as bad spark plugs and ignition coils, a clogged carburetor or a worn out transmission.

The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
As a general rule, avoid slopes that are steeper than one foot of incline for every three feet of horizontal width. Most lawn tractors and zero turn mowers can handle slopes that are only one foot of incline for every four feet of horizontal width. Know your model`s limits and stick within those boundaries.
Over time, a spark plug will wear out. Eventually, the spark will no longer be powerful enough to fully ignite the air and fuel. You are likely to notice power loss including bogging down when cutting grass because of a worn spark plug. Removing and replacing a spark plug is easy.
One of the most common problems with hill starts is stalling, which is caused by two things: not pressing on the gas pedal enough and bringing the clutch up too fast (i.e. past the biting point).
Check the Battery

The battery is the next stop when investigating a slow cranking mower. A weak battery cannot sustain enough charge to spin the starter mower and turn the mower`s crankshaft. Mower batteries last around four years, so one that is older may be ready for replacement.

A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
The slope limits of 15 and 22 degrees are based on instructions provided by manufacturers. 0- to 15-degree slope — riding mowers or tractor mowers are approved for these areas. 15- to 22-degree slope — tractor mowers are approved for these areas.
A recommended maximum slope is commonly 15 degrees. However, many individuals cannot evaluate slopes just by sight. Some mower manufacturers have warned about too steep slopes and have provided slope gauges for users to determine the slopes in natural settings.
Mowing on a hill can pose a safety risk. Slopes can cause a loss of traction and stability for riding lawn mowers, which can result in it tipping over and harming the operator. Serious injury and even death can happen, so it`s not a situation to take lightly.
A recommended maximum slope is commonly 15 degrees. However, many individuals cannot evaluate slopes just by sight. Some mower manufacturers have warned about too steep slopes and have provided slope gauges for users to determine the slopes in natural settings.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Mowerdeck will not engage… – John Deere 195HP Hydrostatic 42" Cut Riding Mower
ANSWER : I own a similiar John Deere model (L130, 23HP with a 48″ deck). I would check the electric clutch (called a PTO). To do this check the wires to this clutch and look for something disconnected. These wires (to this PTO clutch) should have twelve volts with the key on and the blades engaged.

Read Full Q/A … : John Deere

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : John Deere

Our john deere 400 is eating the belts for the front pto drive
ANSWER : Flat idler to left of belts is most likely seizing up during use.

Read Full Q/A … : John Deere

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : John Deere

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger
ANSWER :

Read Full Q/A … : John Deere

Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it

Read Full Q/A … : John Deere

What type of oil doe it use – John Deere Gx75 Rx75 Srx75 Sx75 130 9hp Starter
ANSWER : 10W-30 Turf Gard

http://www.greenpartstore.com/John-Deere-GF-3-10W30-Turf-Gard-4-Cycle-Motor-Oil-Quart-TY22029.html

Read Full Q/A … : John Deere