John Deere

After cutting half my yard my tractor stalled. I let it sit for a while and it started up. After a while of cutting it stalled again. My gas window shows a full tank when it shouldnt be that full.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Most problems that will cause a John Deere lawn mower to stall after 20 minutes occur due to the distribution and rate of flow in the fuel and air systems. If these systems are dirty or restricted, the mower will stall out and be difficult to restart.
Tractor may be starving for fuel.

The fuel tank can develop a vacuum. This could cause fuel to stop running to the engine – causing it to stall. If this is the case, give it an hour or two, and the tank pressure will reset and equalize. Then the tractor will run again.

If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
Being Overworked

One of the most common reasons that a lawn mower might stall while it is cutting grass is that it is being overworked. This is a mechanism that is intentionally incorporated into the mower to prevent the motor from being blown.

The spark plugs are worn or damaged

If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.

Lean Air/Fuel Mix

Your automobile needs air and fuel to start and run and it`s the carburetor`s job to mix it. If there is too much air in the mixture, the engine isn`t getting enough gas and can stall. A mixture that is high on air and low on fuel is called a “lean” mixture, and it will affect your engine performance.

Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Common problems on the list include things like uneven grass cutting, slipping belts, or minor engine problems. John Deere also claims that lighting issues and battery problems are common. Still, John Deere tractors are largely reputed for their reliability.
As the fuel level drops, a vacuum begins to form in the fuel tank because air can get in to fill the space the consumed fuel occupied. After about 10 or 15 minutes, the vacuum will become strong enough that fuel will stop flowing to the carburetor and the lawnmower will die.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

The most common cause of a mower that runs for thirty minutes and then dies is a faulty armature. A faulty gas cap is the second most likely cause.
If the engine dies when the blades engage, it could be the result of a damaged safety switch. The first step in assessing the safety switch is to make sure it is plugged in securely. The switch is located underneath the seat, and you may have to remove the seat to reach it.
The most common reason for a surging lawn mower engine is a blockage in the fuel supply, but there are other possibilities: Bad gas. Bad spark plug. Dirty/faulty carburetor.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

How do I change the gas tank on my John Deere L110 Lawn mower
ANSWER : Howdy, I have a jd L110 automatic with 179 hours on it…some times when starting with the brake held down it will not crank…some times it will… I am not sure if it is the switch on the brake or the starting system…Is there any way with out buying a new switch to wire jump the switch to see if it is in the switch or not? thanx, Dan

Read Full Q/A … : John Deere

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : John Deere

L110 bagger installation
ANSWER : I can’t help you on the bagger hole location. But you will need quality hi-lift blades. “Gator-Blades” are some of the best. At www.mowpart.com or Amazon.com

Read Full Q/A … : John Deere

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : John Deere

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger
ANSWER :

Read Full Q/A … : John Deere

Our john deere 400 is eating the belts for the front pto drive
ANSWER : Flat idler to left of belts is most likely seizing up during use.

Read Full Q/A … : John Deere

What size – Length belt fits L110 – John Deere L100 Series
ANSWER : Model # GX20072 is for a 42 inch deck . It fits a variety of John deere mowers

Read Full Q/A … : John Deere