22HP VTwin 48″ Riding Mower

Experienced gardeners share their insights in answering this question :
With a manual

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If no spark appears, check for broken wires, shorts, grounds or a defective stop switch. Once you have confirmed that the stop switch is working, reconnect the spark plug lead.
If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap.
An engine misfire is when one or more cylinders doesn`t produce power, and there are several possible causes, from a fouled spark plug to a clogged fuel injector or faulty oxygen sensor.
A single spark plug that fails to ignite the fuel-air mixture can cause a halt in the running of the engine. It can result in incomplete combustion and damage to the catalytic converter of the car. Faulty spark plugs can cause the car to exhibit starting troubles.
If you do not see a spark, there is an ignition problem. Remove a plug wire and insert an old spark plug or a spark plug tester into the end of the wire (the plug boot). Place the spark plug on a metal surface on the engine, or ground the spark plug tester to the engine. Then crank the engine to check for a spark.
When couples say they no longer feel a “spark,” it may mean that they`re missing the initial feeling of infatuation or that long-term commitment has become challenging. Meeting your partner and falling in love may have felt exciting, new, and intense. You might have felt that it was the only factor in your life.
Using WD-40 to repel water is a good way to prevent corrosion and keep moisture away. You can also use it to ease the removal of spark plugs, especially if there is any rust or corrosion.
You can replace one coil at a time or all at the same time. I would however recommend having all spark plugs replaced with the coils so you do not have to remove coils twice.
Spark plugs aren`t universal; you have to make sure that you buy one that fits your mower. You can consult your owners` manual to determine the types your lawn mower can use or take a look at the plug`s ceramic insulator, which usually has the number printed on it.
How can I tell if my ignition switch is failing? A bad ignition switch will have problems with starting the engine, keeping it running, or engaging other systems when the key is turned. You might also have issues turning the key.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Spake plug is not spakeing – John Deere Original 130 160 165 175 180 185 Operators
ANSWER : Hi Lloyd
Make sure you are getting spark at the spark plug, to do this:Remove your spark plug and check to be sure you are getting a bright blue spark at the spark plug.You do this by grounding the plug on the head of the engine and cranking the engine or by pulling the crank rope…watching the plug for spark.If you are getting a nice blue spark then skip A below and go to B.
A…If you do not get a nice blue spark then you may need to replace the electronic module.Note: If you have to replace the module be sure to measure the position it is in, it is critical to starting.The clearance can be measured with a “business card”…use the card for the right clearance between the coil and the flywheel.Take a picture for later reassembly.
B…Also take some fine grit sandpaper (not emery) and lightly sand the flywheel where the magnet is located to clean any rust or corrosion from the magnet area.Please rate meBud

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

What type of oil doe it use – John Deere Gx75 Rx75 Srx75 Sx75 130 9hp Starter
ANSWER : 10W-30 Turf Gard

http://www.greenpartstore.com/John-Deere-GF-3-10W30-Turf-Gard-4-Cycle-Motor-Oil-Quart-TY22029.html

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

What is the spark plug gap for a john deere 14sb lawnmower with a kawasaki engine
ANSWER : Check this link for more information .025

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

John Deere L 130 no spark from one cylinder. How do I replace the coil
ANSWER : With a manual

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

Weak fire out of coil wire – John Deere Pto Clutch For Stx38 And Stx46 Lawn Mowers
ANSWER : This can be due to a dirty flywheel, an improper gap between the flywheel and coil, or a coil that is failing, first check for rust or dirty build up on the flywheel, then check for proper gap, and if neither of those are the issue, replace the coil

Read Full Q/A … : 22HP VTwin 48″ Riding Mower

I have John Deere GX345. It does not start consistently. When it doesn’t start the plugs have no spark. The problem is intermittent.All electrical connections look clean and no corrosion. Re- seated all connections. Fuel flow is good because I can smell raw fuel while cranking the motor. I replaced the fuel lines last year. Thank you for your help. Daryl Witowski
ANSWER : Look for a small silver box with 1 wire on it mounted to the motor. It is a temp sensor and will keep it from firing…Just had to replace mine…

Read Full Q/A … : 22HP VTwin 48″ Riding Mower