John Deere
Experienced gardeners share their insights in answering this question :
THE IGNITOR FIXED MY NO SPARK PROBLEM. THE 1 INCH SILVER BOX ON TOP OF ENGINE.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The most common reason a gas or diesel Gator won`t start is a battery that has run down, either due to the Gator not having been used for a few weeks or purely from old age. Gator batteries are renowned for their incredible longevity, often lasting up to ten years or even longer.
13/16 in. Pre-Gap Size: . 032 in.
If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
The Gator™ TX 4X2 is powered by an 11.6-kW (15.5-hp)*, 675-cc (41.2-cu in.), V-twin, four-cycle gas engine.
When the high voltage produced by the ignition system is applied between the center electrode and ground electrode of the spark plug, the insulation between the electrodes breaks down, current flows in the discharge phenomenon, and an electrical spark is generated.
If the spark plug and the rest of the ignition system are working properly, you should see an obvious blue spark arcing between the tip of the inner central electrode of the plug and the curved metal top that arcs downward near it as the engine turns over.
Importance of the Spark Plug Gap
The gap is the distance between the center and side electrodes, set so arcing occurs at the proper voltage that ignites the fuel and generates the combustion that makes the engine run.
Just as importantly, John Deere recommends you change your spark plugs every 100 hours or once a mowing season.
Max speed of 20 mph.
John Deere Gator XUV | High Performance – 12 Volt | Toys | Peg Perego United States. Strollers, Travel Systems and Bassinets.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
What is the spark plug gap for a john deere 14sb lawnmower with a kawasaki engine
ANSWER : Check this link for more information .025
Read Full Q/A … : John Deere
Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks
Read Full Q/A … : John Deere
Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger
ANSWER :
Read Full Q/A … : John Deere
How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.
Read Full Q/A … : John Deere
Spake plug is not spakeing – John Deere Original 130 160 165 175 180 185 Operators
ANSWER : Hi Lloyd
Make sure you are getting spark at the spark plug, to do this:Remove your spark plug and check to be sure you are getting a bright blue spark at the spark plug.You do this by grounding the plug on the head of the engine and cranking the engine or by pulling the crank rope…watching the plug for spark.If you are getting a nice blue spark then skip A below and go to B.
A…If you do not get a nice blue spark then you may need to replace the electronic module.Note: If you have to replace the module be sure to measure the position it is in, it is critical to starting.The clearance can be measured with a “business card”…use the card for the right clearance between the coil and the flywheel.Take a picture for later reassembly.
B…Also take some fine grit sandpaper (not emery) and lightly sand the flywheel where the magnet is located to clean any rust or corrosion from the magnet area.Please rate meBud
Make sure you are getting spark at the spark plug, to do this:Remove your spark plug and check to be sure you are getting a bright blue spark at the spark plug.You do this by grounding the plug on the head of the engine and cranking the engine or by pulling the crank rope…watching the plug for spark.If you are getting a nice blue spark then skip A below and go to B.
A…If you do not get a nice blue spark then you may need to replace the electronic module.Note: If you have to replace the module be sure to measure the position it is in, it is critical to starting.The clearance can be measured with a “business card”…use the card for the right clearance between the coil and the flywheel.Take a picture for later reassembly.
B…Also take some fine grit sandpaper (not emery) and lightly sand the flywheel where the magnet is located to clean any rust or corrosion from the magnet area.Please rate meBud
Read Full Q/A … : John Deere
My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.
Read Full Q/A … : John Deere
I have John Deere GX345. It does not start consistently. When it doesn’t start the plugs have no spark. The problem is intermittent.All electrical connections look clean and no corrosion. Re- seated all connections. Fuel flow is good because I can smell raw fuel while cranking the motor. I replaced the fuel lines last year. Thank you for your help. Daryl Witowski
ANSWER : Look for a small silver box with 1 wire on it mounted to the motor. It is a temp sensor and will keep it from firing…Just had to replace mine…
Read Full Q/A … : John Deere
Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it
Read Full Q/A … : John Deere
