Electric PTO Clutch for Cub Cadet, MTD and Warner

Experienced gardeners share their insights in answering this question :
Adjust the clearance between the plates,9/16 wrench and turn the three nuts on the clutch one at a time about 1/4 turn each,retry the clutch,repeat until it works normally.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Powershift PTO engagement problems could be from blocked hoses or fittings, bad connections or ground or the solenoid. Mechanical PTO engagement problems could originate from low air pressure, improper cable installation or back lash too tight.
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.
Sudden failure is most often caused by a broken or loose clutch cable, linkable or a failed hydraulic master/slave cylinder. There can also be leaks in the hydraulic line or even the disc could be contaminated with something like dirt or debris.
To engage the blades, be sure that your throttle or choke is in the rabbit position. Then, push the PTO or blade engage lever forward into the on position.
A company gives its employees a set amount of PTO hours, which reset annually. Some employers reset PTO hours by hire date; others reset them on January 1.
Economy PTO allows the tractor to operate at the required 540 rpm at the PTO but with lower engine rpm, which saves fuel, reduces vibration, and reduces noise.
Function/description : To indicate that the PTO shaft rotates clockwise. Main field of application : Agricultural tractors and equipment.
For power shift operation, when a power shift PTO is engaged, a solenoid is energized. Air or hydraulic fluid then compresses a clutch pack in the PTO. This locks the PTO output gear to the output shaft and allows work to be done. When the power shift PTO is disengaged, the solenoid de-energizes.
This operation is crucial to the overall functioning of riding mowers, and thus PTO clutch repair may need to be immediately performed on riding mower models that have a failed clutch. Fortunately, you can fix your clutch irrespective of your experience with PTO clutch installation.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

John deere 240 brand new electric clutch. went I throw the swtich it clicks but doesn’t engage….
ANSWER : Adjust the clearance between the plates,9/16 wrench and turn the three nuts on the clutch one at a time about 1/4 turn each,retry the clutch,repeat until it works normally.

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

John deere stx 30 pto wont engage
ANSWER : Check your fuse or for a broken wire( or shorted)

Weak fire out of coil wire – John Deere Pto Clutch For Stx38 And Stx46 Lawn Mowers
ANSWER : This can be due to a dirty flywheel, an improper gap between the flywheel and coil, or a coil that is failing, first check for rust or dirty build up on the flywheel, then check for proper gap, and if neither of those are the issue, replace the coil

I am trying to find a new or second-hand bonnet for my john deer stx38. i live in the gippsland area. any suggestions?
ANSWER : I use www.greenpartstore.com

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger

Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it