John Deere

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

As a general rule for most engines, 10-15 PSI is a good minimum for hot idle, and 40-60 is good for hot working speeds. Check the Deere manual to be sure though.
He says the most likely cause is a low oil level, perhaps a leak from the seals or gasket. There could also be a plugged filter. But, the light might be an alert of something more serious, such as worn bearings, crankshaft, or oil pump.
The unit of measurement is either PSI or Bar. The ideal oil pressure varies depending on the car brand and model, but generally, the ideal oil pressure is between 25-65 PSI.
Normal engine oil pressure is between 25 and 65 PSI. While the ideal oil pressure can change depending on the make and model of your car, the general rule is that oil pressure should be above 25 and below 65 PSI (pounds per square inch).
In general, if the pressure is below 20 PSI or under the normal range on the gauge it requires your immediate attention. This is also the case when your oil pressure light is coming on. Not diagnosing and treating the problem could lead to serious damage and high repair costs.
Once the oil is at normal operating temperature, the oil pressure should indicate around 4 bar at 5,000 rpm. It takes the oil longer to reach its normal operating temperature than the coolant.
For most semi-trucks, the normal operating oil pressure is between 40-50 PSI (pounds per square inch).

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Oil capacity my dipstick does not have a fill line. how much oil do I put?
ANSWER : Oil capacity 1979 Ford Thunderbird 5.8 litre

Read Full Q/A … : John Deere

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

What type of oil doe it use – John Deere Gx75 Rx75 Srx75 Sx75 130 9hp Starter
ANSWER : 10W-30 Turf Gard

http://www.greenpartstore.com/John-Deere-GF-3-10W30-Turf-Gard-4-Cycle-Motor-Oil-Quart-TY22029.html

Read Full Q/A … : John Deere

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : John Deere

Our john deere 400 is eating the belts for the front pto drive
ANSWER : Flat idler to left of belts is most likely seizing up during use.

Read Full Q/A … : John Deere

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : John Deere

Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it

Read Full Q/A … : John Deere

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger
ANSWER :

Read Full Q/A … : John Deere