Consumer Products MightyLite Handheld Gas Blower with…

Experienced gardeners share their insights in answering this question :
The bulb repair kit can be purchased a home depot or lowes, or whatever is close to your home. These can be replaced fairly easy. It is usually prongs on the backside that hold the bulb in. After pressing these the bulb will come out of the housing and disconnect the tubing from the bulb. It a good idea to replace tubing when doing this, the tubing is rotted or dried out and eventually cracks. Keep in mind where the tubing goes. One will feed from the gas tank and the other will feed the carb.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Gas models that start will a pull rope include a primer bulb to deliver a gas and air mixture to the carburetor to start the engine. Primer bulbs that have cracks or tears in them need replacing to start a gas leaf blower.
Homelite blowers are designed for unleaded automotive gasoline with an octane rating of at least 87.
The Homelite BP250 back pac blower has a foam air filter. It uses a mix of engine oil and gasoline (50:1 ratio) for fuel. The exact mix is 2.6 oz. of two-cycle engine oil per one gallon of gasoline.
There are different types of gasoline primer bulbs, all of which contain various types of valves inside. Sometimes these bulbs become so hard it`s difficult to squeeze them; sometimes even though you can squeeze them, they pump poorly, if at all.
Once the engine is running, the feed pump produces a suction that draws fuel through the bulb valves. Without the fuel coming in through the bulb, this feed pump cannot work properly. The use of the primer bulb is therefore crucial.
Placement should be considered first. The filter should be installed in the outlet line that delivers fuel to the engine, after the tank outlet fitting but before any fuel pumps, regulators, primers or primer bulbs, or other filters.
Placement should be considered first. The filter should be installed in the outlet line that delivers fuel to the engine, after the tank outlet fitting but before any fuel pumps, regulators, primers or primer bulbs, or other filters.
Press the primer bulb a handful of times to prime the engine – some models will require three or four pulls while others will need at least five or six. Place the leaf blower on the ground so that it`s secure. Ensure you have a firm footing and press down on the unit with one hand.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Is it possible to replace a primer bulb on a homelite blower?
ANSWER : The bulb repair kit can be purchased a home depot or lowes, or whatever is close to your home. These can be replaced fairly easy. It is usually prongs on the backside that hold the bulb in. After pressing these the bulb will come out of the housing and disconnect the tubing from the bulb. It a good idea to replace tubing when doing this, the tubing is rotted or dried out and eventually cracks. Keep in mind where the tubing goes. One will feed from the gas tank and the other will feed the carb.

My primer bulb cracked, can I replace it? – Homelite Consumer Products Backpack Blower/Vac, Carb
ANSWER : Yes, in fact event he DIY centers have parts like that available off the shelf or ACE Hardware. You will need the specific model number to ensure you get the right part or bring the old part with you.

Why won’t the Prime bulb fill on blower and how to fix?
ANSWER : YOU HAVE THE PRIMER BULB HOOK UP WRONG TRY CHANGING THE FUEL LINES

Replace a primer bulb on a Homelite Mighty Lite 26cc trimmer
ANSWER : There should be two to four screws right around the primer bulb cover, which is located around the primer bulb. Remove those and switch the primer bulb out.

Where to find a replacement primer bulb for Homelite model SX-135 Bandit?
ANSWER : Here is the part you need for your Walbro carburetor.
http://www.ereplacementparts.com/search_result.php?type=search-part&q=01201&manufacturer=Homelite

MY homelite BP-240 backpack blower will not run with out the assist of starting fluid. First I tried to start it with just pushing the gas primer bulb. after no success I just sprayed start fluid . It will run continus if I keep spraying( just 1 pull to start ). what can I do to repair it!
ANSWER : Dont spray starting fluid in there to start it has to have a gas oil mix for the piston to have lubrication it will scar or burn the piston and cylinder wall check the fuel lines to see if they need replaced and the fuel filter also the priming buld to for cracks etc.

Gas leaking from damaged plastic bulb on primer. How ccan I replace it? Homelite Trimmer ST 175G.
ANSWER : If its built into the carb, 2 screws and a cover plate hold it in place. If it is externally mounted, if you look at it closely, you will see it may be snapped into place in the cover its in. Small engine shops and Ebay have the replacements.

Primer wont work fs45
ANSWER : Rebuild carb