Garden

Experienced gardeners share their insights in answering this question :
Switch on prime the Carby pull choke on pull starter cord.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Get to work faster. Smart Start is Husqvarna`s name for the technology that evens out the increase of momentum that develops when the piston reaches its highest level. This makes it easier to pull the starter rope, which – in the long run – saves both time and money for you and your business.
Check the air filter and spark plug on the Husqvarna 350. If the air filter is clogged or dirty, clean it or replace it with a new one from Husqvarna or an online parts house. You can test this by trying to start the saw without the air filter. Some parts houses offer maintenance kits that include the filter.
If the spark plug produces a spark and you are still having difficulties starting your chainsaw, it`s time to check the gap. The spark plug gap is an air gap between the ground electrode and the center electrode. If the gap is too small, the spark struggles to ignite the fuel and air mixture.
Smart Start is one of Husqvarna`s unique technology because when their chainsaws are installed with it, it means it`s extremely easy to start.
If it is difficult to start the ride-on mower, the most common reasons include: Old fuel; make sure to use fresh fuel, especially after winter storage. Spark plugs might be dirty or damaged. How to examine and replace a spark plug on your ride-on mower.
Hold the front handle firmly with your left hand. Pull the starter handle with your right hand. Repeat until the engine fires. Push the choke (half-throttle) and pull until the saw starts.
If your chainsaw still starts and then stops working, check the air filter. Clean or replace the air filter if it is dirty or damaged. Another reason that your chainsaw starts and then stops working could be that the spark arrestor is dirty or clogged. If this is the case, clean it with a wire brush.
If your chainsaw still starts and then stops working, check the air filter. Clean or replace the air filter if it is dirty or damaged. Another reason that your chainsaw starts and then stops working could be that the spark arrestor is dirty or clogged. If this is the case, clean it with a wire brush.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Hard to Start – Husqvarna 435-BRC-RB Chainsaw
ANSWER : Do you have good compression, good spark and is fuel getting into the cylinder.? More information is required

Read Full Q/A … : Garden

Have spark wont start – Husqvarna Chain Saw 18" 450 Model 966955438
ANSWER : If there is a good spark at the plug, it can be one of two things, either the piston has picked up in the cylinder ( remove the muffler and check the condition of the piston skirt through the exhaust port ) or there is no fuel getting the the plug ( replace the fuel filter in the tank )

Read Full Q/A … : Garden

Sputtered, died. Will not start anymore – Husqvarna Lawn Tractor – 54in. Deck, 26 HP, Model# LGT2654
ANSWER : Sounds like the carburetor needs cleaned and maybe rebuilt. If you can spray a little starting fluid (or a little carb. cleaner or anything volitile) into it and it starts and dies, you know it is in the carburetor.I hope this helps.

Read Full Q/A … : Garden

Cannot get the saw started – Husqvarna 450 e-series 18" Chain Saw
ANSWER : Check for spark check fuel filter carb kit if sitting for while new plug

Read Full Q/A … : Garden

Husqvarna 345e Hard to start and when it does start it continues to run (chain).
ANSWER : I have a model 435 Husky that had the same hard-to-start problem–warranty service replaced the carburetor and it seems to work ok now. The chain that continues to turn can be fixed by turning the idle-speed screw (not the H or L jet screws) CCW a small amount until it can be accelerated then dropped back to idle to quit driving the chain. Hope this helps!

Read Full Q/A … : Garden

I HAVE A HUSQVARNA YTH20K46. IT STARTS AND THEN DIES. IT WILL NOT RESTART. ABOUT 15 MINUTES LATER IT WILL START AGAIN AND DIE AFTER ABOUT 5 SEC. IS IT STARVING FOR GAS?
ANSWER : If it starts and dies on choke.. then try these two things. Take the bulb off of the carborater and clean it out and clean spray the 2 holes that put gas into the float bulb. Also change the spark plug. This will fix your problem!

Read Full Q/A … : Garden

I’m having problems with my 223L when I cen get it started I have to run it with full choke once you open the choke it shuts down any help Please
ANSWER : Sounds like its getting fuel starved, look at fuel system and carb settings, may need a carb service.

Read Full Q/A … : Garden

Colk start trigger isi'nt working – Husqvarna Models 61-66, 266, 268, 272
ANSWER : More details needed. how not working

Read Full Q/A … : Garden

My name is June Strandberg, and I am a florist and gardener in San Francisco. I have been working in the industry for five years, and I love helping people find the perfect floral arrangement for their special occasions. I am also skilled in troubleshooting and fixing gardening tools, so if you are ever having trouble with your tools, please don't hesitate to reach out to me.