Garden

Experienced gardeners share their insights in answering this question :
Put your half moon key in put antiseize on inside of the adaptor and shaft slip it on some cases hammer it on tighten any allen lock screws down if any install the blade

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

It`s important that the blade`s cutting edge follows the direction of rotation. The wings of the lawn mower blade will be oriented up toward the mower deck, and any writing on the blade will likely be facing away from the deck. If the blade bolt comes with a washer, its concave side will be facing the blade.
Most lawn mower blades have a round center hole that is used to connect the blade to the spindle.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Lawn mower motor runs good, the drive wheels run good but the blade won’t stay enguaged. Thanks
ANSWER : Check your cable that controls the blade engagement.

Read Full Q/A … : Garden

When I hold the bar down that engages the blade it will not cut?
ANSWER : Is the blade sharp?

Read Full Q/A … : Garden

My bolens mower leaking oil only when running…help me please bought brand new last year..
ANSWER : You have to replace lower seal you have to take off blade the blade adapter then take a screw driver and slowly pry out old seal remove it take new seal cover it with oil all over completly cover all the rubber on the new seal slip down the shaft seal facing up tapit in using a hammer keep going around the seal till its seat into place replaces parts and should not leak any more

Read Full Q/A … : Garden

Lawn mower cranck but wont start…
ANSWER : Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.

Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.

Read Full Q/A … : Garden

Does briggs&Stratton have shaft extensions to lower my blade 1in. or 2
ANSWER : Are you sure you have the blade on the right way or the right blade for the mower?

Read Full Q/A … : Garden

Bosch electric lawn mower wont start, how do I fix it?
ANSWER : Cable damaged …renew cable . ..if does not work try condenser.

Read Full Q/A … : Garden

Where is oil drain plug on MTD mower – Mtd LAWN MOWER PART # 683-04163B FRAME Assembly:RIDER
ANSWER : If it isn’t on the bottom of the engine (above the blade) then you don’t have one. This is not that uncommon. When you need to drain the oil, FIRST- pull the spark plug wire off!!! Then remove the dip stick or filler plug and turn the unit upside down and drain the oil.

Read Full Q/A … : Garden

How do i add transmission oil – Ariens Lawn Tractor 46"" Riding Lawn Mower 936053"
ANSWER : Should a plug or cap on top of transaxle.

Read Full Q/A … : Garden