John Deere

Experienced gardeners share their insights in answering this question :
Check the drive belt from pulley on crankshaft to the rear axle could have broken or jumped off the pulley

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If your lawn mower turns on but won`t move, there could be a number of potential causes. The most common issues include a broken or damaged belt, a clogged discharge chute, a broken or damaged drive cable, or a damaged or clogged transmission.
Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator`s manual, you`ll find a section that covers oil viscosity.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
Over time, dirt, debris and other tiny particles can accumulate in the transmission fluid, affecting its fluid properties. This can cause the vehicle to die when you shift into drive or reverse, allow a loss of power, transmission slip, rough shifts or even prevent the vehicle from shifting into gear at all.
The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
If you attempt to push a tractor with a hydrostatic transmission, it causes fluid to move backward through the pump and can damage the seals. You must disconnect the drive before moving your lawn tractor.
If your John Deere won`t crank and all you hear are clicking sounds when you turn the key, you likely have a bad battery or a bad connection somewhere between the battery and the starter. Double check that the alternator and battery connections are clean and tight.
A Dirty Carburetor Can Cause a Lawnmower To Start Then Die

By far, the most common issue that causes a stalled motor is a dirty carburetor. The carburetor on your engine is the thing that draws in air and mixes it with the fuel. Contrary to what the movies might make you think, gasoline itself is not very flammable.

Grinding gears, starting and stopping during operation, and the wheels not rotating with the pulley are common signs that your mower`s transmission is breaking down.
Touch the metal shaft of a screwdriver to both of the large terminals at the same time. If the engine turns over and starts, the solenoid is bad and should be replaced. If the starter motor does not run, the motor itself is probably defective.
Grinding gears, starting and stopping during operation, and the wheels not rotating with the pulley are common signs that your mower`s transmission is breaking down.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : John Deere

I have arx75 rining mower when i put it in gear it does not move when i raise the rearend up in the air the tire spin what could be wrong with it
ANSWER : Http://www.fixya.com/support/t9023324-replaced_transmission_john

Read Full Q/A … : John Deere

John deere stx 30 pto wont engage
ANSWER : Check your fuse or for a broken wire( or shorted)

Read Full Q/A … : John Deere

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : John Deere

What type of oil doe it use – John Deere Gx75 Rx75 Srx75 Sx75 130 9hp Starter
ANSWER : 10W-30 Turf Gard

http://www.greenpartstore.com/John-Deere-GF-3-10W30-Turf-Gard-4-Cycle-Motor-Oil-Quart-TY22029.html

Read Full Q/A … : John Deere

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : John Deere

I am trying to find a new or second-hand bonnet for my john deer stx38. i live in the gippsland area. any suggestions?
ANSWER : I use www.greenpartstore.com

Read Full Q/A … : John Deere

Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it

Read Full Q/A … : John Deere