Garden
Have a bad Craftsman fuel line. It is cracked
Experienced gardeners share their insights in answering this question :
If you go to http://www.searspartsdirect.com/partsdirect/brands-products/Craftsman-Parts/Riding-mower-tractor-Parts and us the 917. model number you will be able to get exploded views of what you want..
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Replacing the fuel hose on your vehicle is going to take time and patience, and it could require getting underneath the car. It`s also going to take the right tools for the job.
Fuel line. 15 Inches of of 1/4 inch inside diameter hose.
Tools to Repair a Metal Fuel Line. You will need two inexpensive special tools for this repair – a short handheld tubing bender and a tubing cutter. The cutter has two opposing cutting wheels that position over the fuel line. Rotate and tighten the tool until it cuts through the line, making a perfect cut.
If you need fuel hose replacement, the average cost can vary a lot depending on the make and model, anywhere from $120 to $500 or even more. Older cars are more susceptible to fuel hose leaks as newer models typically use hard fuel lines more often.
Gas can leak from your vehicle`s undercarriage if the gas lines are kinked or the hoses aren`t installed correctly. A fuel line leak is an easy fix for a repair shop, costing around $60 to $120.
Ignored a fuel line leak
Most cars have a metal line that runs the length of the car with rubber fuel lines connecting at either end, one at the fuel tank and the other to the engine. Fixing a leaking fuel line is a simple task for a repair facility and costs between $60 and $120.
Standard rubber vacuum or heater hose should never be used in fuel applications. The hose will deteriorate from the inside out and can plug fuel filters and carburetors with rubber debris, long before it springs an external leak.
They are usually made from stainless, aluminum or coated steel tube. Metal is the best material for fuel lines. However, it can be difficult to fabricate.
Replacing the fuel line on your vehicle can take anywhere from two to six hours. Depending on your car`s make and model, it may be a complicated procedure that involves removing many components.
car, yes, you can replace the low-pressure return metal line with rubber, doesn`t need to be high-pressure F.I. hose. There should be a rubber section where it connects to the tank, 7.5mm. 5/16″ will also work.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Need to replace fuel lines on my Troy Bilt gas hedge trimmer. Where can I get replacement fuel lines… or better yet… what size are the lines and where can I buy a few feet of the lines. Note: I have reviewed the parts assembly and it would seem to indicate I have to replace the entire handle assembly (Part #1) instead of just buying replacement hose(s). Any help to resolve my issue would be greatly appreciated and thanks in advance
ANSWER : Replacement fuel lines should be readily available at your local lawnmower repair shop. Your TroyBilt hedger uses fuel line that is 3/32″ (2.4mm) interior dimension, 3/16″ (4.8mm) outside dimension, with a 3/64″ (1.2mm) wall dimension.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.
Make sure to clean the in-tank filter when replacing hoses.
Good luck.
Read Full Q/A … : Garden
My fuel lines are coming apart and I need to install new ones.
ANSWER : Go to sears direct, enter your model number and get a schematic of your tool. you can also order factory parts at that site. Just replace them just the way they are now and be sure to tighten down the hose clamps well, if they come with hose clamps. some do not and rely only upon friction fit. Joe
Read Full Q/A … : Garden
Need to replace fuel lines….does the prime bulb connected to return fuel line or the supply fuel line
ANSWER : Hi stglass900…
Normally the big line will be the line the fuel filter is connected to inside of the tank, and is connected to the primer bulb.
The smaller of the two lines is the return line to the fuel tank from the carburetor after it is pumped thru the carburetor by the primer bulb.
Please take time to rate me
Read Full Q/A … : Garden
Replaced fuel lines, will not stay runing with chock off
ANSWER : Obviously, additional air can be anywhere. Check all connections that are possible from the air filter to the cylinder.
Read Full Q/A … : Garden
The fuel lines have rotted out of the edger gas tank. How do I fix or do I need to replace entire tank with new fuel lines?Since there are no male fuel line connections exiting the fuel tank and just two holes where the lines were, I guess I need to replace the entire tank and get a new one with lines already attached. Thanks.
ANSWER : No you can buy replacement fuel line but you must reconnect the filter in the tank that line goes to the bottom of the carby then out the top of the carby to the inlet on the primer then out of the primer and back to the tank.
Read Full Q/A … : Garden
Replaceing fuel line in polan 3300 chain saw – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Hi owjbhend…
Use a piece of wire and insert it into the fuel line, then bend a hook in the end and hook it over the end of the fuel line…lubricate the fuel line with some vaseoline very lightly…about the first one inch of the fuel line and then use your fingers to start the fuel line into the tank, once you have the fuel line in the tank give enough to hook the fuel filter to and so it can be dropped back into the tank.
Below is a drawing of how to route the fuel lines.
Please take time to rate me thumbs up
Please take time to rate me thumbs up
Use a piece of wire and insert it into the fuel line, then bend a hook in the end and hook it over the end of the fuel line…lubricate the fuel line with some vaseoline very lightly…about the first one inch of the fuel line and then use your fingers to start the fuel line into the tank, once you have the fuel line in the tank give enough to hook the fuel filter to and so it can be dropped back into the tank.
Below is a drawing of how to route the fuel lines.
Please take time to rate me thumbs up
Please take time to rate me thumbs up
Read Full Q/A … : Garden
I need to replace the fule line on my weedwacker 25cc. Where does the fuel fileter go inside the tank, attached to the smaller or larger fuel line?
ANSWER : Larger
Read Full Q/A … : Garden
I need to replace fuel line in Weedeater trimmer. How can I do it ?
ANSWER : Enter Weed Eater fuel lines in the search field for numerous results and if not, repost here.
Read Full Q/A … : Garden
