Riding Lawn Garden Zero Turn Tractor
Experienced gardeners share their insights in answering this question :
Try sears parts online
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
14 PSI for front tires.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I need a replacement front tire for my cub cadet ztr
Try sears parts online
I have a cub cadet 2165 I just put in a new battery and it is slow turning over any ideas?
If battery is good and everything is hooked up right. Most likely could be the pto clutch bearing. Not the bearing on the pulley but on the clutch inside. Had the same problem, took the spark plugs out got it free. Turned over easy with plugs out, Started right up after and then burned up my bearing. Don’t burn up bearing. If do field assy. For that is 200$ if you can get away with just that. Otherwise 350-400$ for full assy.
PTO will not engage on my 0 turn Cub Cadet RZT 50. What should I check and how do I check it?
See if the switch is getting power to it and if it is see if the clutch is getting power. it needs 12 volts in order to engage.
Where is the fuse – Cub Cadet LTX 1042 KW 42" 18HP Kawasaki Lawn Tractor – 13WG93AS010
Behind the dash panel at top of dash there is only one fuse
Cub cadet 1050 changed oil now its wants me to change oil again and it smokes really bad now to much oil or too little
The 1050 holds 57.5 oz slightly less than 2 qts 64 oz. the filler stick is marked. shiould be over the add mark not over the full mark
Cub Cadet zero turn. Cannot get the blades to turn when PTO switch is pulled. Belts are fine and attached. Please help.
I had the same problem. there was a short in the relay just before the wire gets to to back pulley assembly.
How to speed up reverse – Cub Cadet Op's Manual Model Lt1042 Lt1045 Lt1046 Lt1050
Only way is to change pulley size on pump / has built in gear
I have a cub cadet LT1042 and it is 3 years old…we have replaced the pto 2 times and replaced the belt 7 times what is the deal
You have to have something rubbing under there that isn’t supposed to be, crawl under the tractor and watch the belt go around by hand, if you can turn it. Maybe see what is frozen up, in the wrong place, Gotta be a belt guide is rubbing or a pulley is not spinning. The PTO should last 20 years, all i can think is they got it too tight to start, .010″ min, that is tight, and you must be in Florida picking up a lot of sand? If it was under any kind of warranty, I would raise a big stink about it. Those PTO’s are not cheap. And the belt has got to be $20. I wouldn’t go to a dealer for the belt, unless it is really special, just match it up at the auto parts store, for half the price of dealer. Hope this helps.