it doing this and how can i resolve it
Garden

I followed all the instructions but nothing works

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If your non-starting chainsaw is electric

If you have an electric chainsaw that won`t start, first make sure that the power cable is connected to the mains, then check whether the cable and plug are damaged. If they aren`t, the problem could lie in the motor which, for example, may have worn or damaged brushes.

If the clutch pads are worn out, the motor will run, but the clutch pads will not engage the clutch drum. As a result, the chain won`t turn. Make sure that the stop lever is disengaged. If the stop lever is engaged, the chain won`t turn.
If your chainsaw still starts and then stops working, check the air filter. Clean or replace the air filter if it is dirty or damaged. Another reason that your chainsaw starts and then stops working could be that the spark arrestor is dirty or clogged. If this is the case, clean it with a wire brush.
A dirty carburetor, bad gasoline and low-quality two-stroke oil that creates deposits all contribute to chainsaw starting problems.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Chainsaw is new but chain will not move. Is there a safety feature causing this, or what is the problem?
ANSWER : All machines today will have a chainbrake, this is normally a band that comes around the clutch drum to stop the chain in the event of a kick back, to unlock the brake, pull the hand guard fully back to the top handle until you hear the click of the brake loading, there will be an amount of force required to pull the guard back.

Read Full Q/A … : Garden

Kill switch doesn't work, how do i fix it? – Husqvarna 350 18 Inch Gas Chainsaw 52CC Fully Assembled Brand New 18"
ANSWER : The switch connects directly to the coil body of the ignition module. You may have to remove the left side cover to expose the ignition module. The switch, when off, connects this wire to engine ground. There may be debris in the contacts of the switch that prevent contact. You will have to remove the air cleaner assembly and maybe the carburetor itself to access the switch. Good luck!

Read Full Q/A … : Garden

White smoke came from chainsaw now wont work – Poulan 14" Electric Chainsaw
ANSWER : Unit is flooded out Remove the plug and clean it or replace it and blow compressed air into plug hole to remove excess fuel.

Read Full Q/A … : Garden

Chainsaw trips circuit breaker
ANSWER : Does the circuit breaker trip before squeezing the switch? Check the power cord – there’s a shortDoes the chain move freely before squeezing the switch? If not, and the circuit breaker trips while squeezing the switch, your chain is too tight.Bottom line – tell us when the breaker trips and what you were doing when it tripped.

Read Full Q/A … : Garden

What type of oil do I use with my Poulan 14″ Electric chainsaw Model PLN1514
ANSWER : It should be standard Chain/bar oil you can get this at lowes or home depot

Read Full Q/A … : Garden

Ryobi PCN 4545 starts perfectly but chain will not turn.
Can you help?
ANSWER : Hi, have you released the chainbrake? Regards Phil.

Read Full Q/A … : Garden

Electric chainsaw What kind of oil to put in i t regular motor oil or something else
ANSWER : A light weight motor oil is fine. I have used it for years with no problem.

Read Full Q/A … : Garden

How to repair a chainsaw
ANSWER : Your clutch springs are weak. replace springs or clutch assembly

Read Full Q/A … : Garden