Garden

Experienced gardeners share their insights in answering this question :
Try and clean the carb

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

A faulty or dirty spark plug could be the reason your lawn mower won`t stay running. It might produce the initial spark, but the spark won`t be enough to keep the engine running if the plug is clogged with dirt and oil. Spark plugs are usually located on the front of a push lawn mower and connected to a black cable.
A dirty carburetor is the most common cause of a lawn mower that starts and then dies. Other possible causes include: Stale/Dirty Gas. Faulty Choke.
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
Most running problems on a Poulan Pro push lawn mower occur due to a decrease in the air and fuel supply needed to power the combustion engine. If the fuel tank and oil supply are fresh and topped off and the engine still won`t stay running, a thorough inspection and cleaning of…
If the motor starts initially but then won`t stay running, that means it`s getting a good initial injection of gas from the primer bulb, but then the carburetor starves off the oxygen it needs to keep combusting. When your carburetor is clogged, the cause is likely to be evaporated gas that has gummed up the pores.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
The spark plugs are worn or damaged

If you find that your lawnmower keeps dying, or keeps stalling while cutting grass, then inspect the spark plugs. Look for signs of damage or wear. Something as simple as a cracked porcelain insulator can mean an electrode has been damaged or burned away.

Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the engine for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
The chain may not have the proper amount of tension. If the adjustment screw is too loose, the chain may not make good contact with the wood. If the chain is too tight, the chain may not rotate at the proper speed, causing the chain not to cut properly. To adjust the chain, tighten or loosen the adjustment screw.
Priming small engines is always important, especially the ones found in most lawnmowers. The carburetors found in the engines are not sealed, which allows fuel to evaporate after some time and leaves the part dry. Left in this condition, the carburetor will not function optimally.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Poulan pro chain wont stay running – Poulan Pro Chain Saw 46cc 20"
ANSWER : Keep “poulan” ha ha

Read Full Q/A … : Garden

It will start but won’t stay running It dies right after it uses up what I pumped in
ANSWER : Carb needs to be cleaned. This new gas we are now forced to use, causes alot of problems.

Read Full Q/A … : Garden

I have a Pouan Pro. I can start it but then when I give it gas it seems to have no power. It doesn’t die, just gets no power. Occasionally it revs.
ANSWER : It may well be running too rich because the air filter is blocked, remove the filter and just try the revs again free running, if ok, clean/replace the filter.

Read Full Q/A … : Garden

Poulan blower was running – ran out of gas – put gas in – won’t start- primed – won’t start – let sit – won’t start-took cover off – sprayed starter fluid in carb – won’t start- -(very little stutter) won’t start-set overnight – repea -twon’t start-wits end !!!
ANSWER : Hello
Does it use a fuel and oil mixture?You probably did that.

Try removing the spark plug and cleaning it with a wire brush or some emery cloth.Make sure you have spark by connecting the plug wire and resting the plug on the metal motor block.

Do not hold the plug in your hand ,if you have no spark you may have a bad magneto.

Read Full Q/A … : Garden

Starts, runs, and dies…starts, runs and dies…starts, runs, an
ANSWER : Sounds like a common fuel problem you need to remove carb & fuel tank and unless you can get a compressor they need a good blast out you may even take carb apart & check diaghram they have very small jets in fact most lawnmower shops have a sonic bath for this

Read Full Q/A … : Garden

MY POULAN PRO 6.5 WONT START….nEED TO REPLACE SPARL PLUG BUT DO NOT KNOW ‘right one”..
ANSWER : Take the old plug out, any auto store should be able to match it up.

Gary

Read Full Q/A … : Garden

Wont stay running – Mtd 22" Yard Machine Push Mower
ANSWER : Under neath the carby is a single brass bolt, undo it

that one bolt is a multi jet, find four holes use a fine pin and carby cleaner ,hint one is at the top were the thread starts , one is in the inside center and two in the sides
put it back in and prim and start, hope it helps

Read Full Q/A … : Garden

My poulan pro 42cc is hard to start ,,, its1 year old an i’m not sure if its worn out from alot of use or if its with the ignition
ANSWER : Throw it out and buy a new one this is a throw away scoiety we live in due to cheap *** chinese **** oh yeah go green

Read Full Q/A … : Garden