through a few degrees after I have pushed it in to lock in it place.
Where can I buy a replacement? How much? How soon to arrive?
Garden

Experienced gardeners share their insights in answering this question :
Here is a site that may have what you need.
http://www.cmsmallengines.net/trimmer-parts-c17/mcculloch-1-2.html

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Spark Plugs. Another common reason your petrol strimmer won`t start could be the spark plug. It is recommended to replace them frequently as a buildup of debris on the electrode may reduce the spark stopping the fuel mixture from igniting.
The most common problem with a strimmer not starting is that there`s a problem with the fuel mix. Double check that you`ve used 40 parts fresh unleaded petrol to 1 part 2-stroke oil (40:1). Check the petrol you`ve used isn`t stale.
When your trimmer starts and runs on choke, it could be because the check valve in the gas cap is clogged. Start the trimmer and gently unscrew the gas cap halfway off. Turn the choke off and assess. If the engine is still running, that means the gas cap may be the culprit.
Turn on the ignition switch and pull the starting cord quickly. You should see a spark in the plug gap. Since the spark may be faint, it may help to do the test in a dark area. If there is no spark, check for a broken or shorted (bare) lead wire or bad switch.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I have a mcculloch trim mac 210 grass trimmer. I have lost the end piece item that pushes into the hub, a small round item that I usually turn through a few degrees after I have pushed it in to lock in it place.
Where can I buy a replacement? How much? How soon to arrive?
ANSWER : Here is a site that may have what you need.
http://www.cmsmallengines.net/trimmer-parts-c17/mcculloch-1-2.html

Read Full Q/A … : Garden

I have the Gh1000 Grass Hog and when using it, the cutting trimmer line went away. Help!
ANSWER : Replace the line….It is a consumable part. It that your question??

Read Full Q/A … : Garden

I have a mcculloch string trimmer with no spark? Do I have to replace the iginition coil ? No spark at end of spark plug wire.
ANSWER : I am assuming you held the wire near the engine while trying to start it? If so then you need to either replace the ignition coil or hopefully just the spark plug wire.If the wire is broken it won’t spark either. You can check the wire with a multimeter set to resistance (ohms) and check for infinite resistance, if you get infinite then the wire is shot.

Read Full Q/A … : Garden

What replacement line do I buy and how do I replace it?
ANSWER : Hello, W/D here.
There are a variety of sizes. Pull your spool off and where the notches are at the bottom ogf the spool are the sizes that your trimmer and spool can use. It’ll read in decimals, like .050, .089, etc.
Best regards, W/D

Read Full Q/A … : Garden

I have a Ryobi 137 trimmer and the whipper head has lost its spinning speed therefore it won’t cut the grass. Any ideas where the problem lies?
ANSWER : You may have too much string out. Try cutting off some if your machine auto cutting blade is gone or really dull

Read Full Q/A … : Garden

I have an Electric grass hog dual string trimmer. One side uses the string in a couple of seconds the other side does fine. i do not have an instruction manual.
ANSWER : Wind the strings in the direction of the arrow on the spool.

Read Full Q/A … : Garden

Im trying to figure out how to install the safety guard.Can you help me?
ANSWER : On this page you will find a tab for the owners manual. The regular site I use has no Worx machines listed at all. I hope this helps you. The tab for MANUAL is near the middle right of this page. Hope the assembly info you need is there.
http://www.worxyardtools.com/cordless/grass-trimmers.html

Read Full Q/A … : Garden

Need to know how to wind trimmer line on trimmer
ANSWER : Depends on the trimmer, all heads are different. However, the majority of trimmers are wound as follows:

1. pop the top cover off the head, pull the spool out. It will be either single or double lined, they will be wound counter clock wise.
2. the end of each line goes out each of the seperate holes
3. slide spool back on and replace cover

www.ButlerPower.com

Read Full Q/A … : Garden