Garden

I got it from a friend and it didn’t work

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The reasons why mower is not moving forward or reverse is that the battery is dead, or due to clogged fuel line. Additionally, malfunctioning transmission, or a broken drive belt, also a faulty spark plug, even when friction wheel isn`t in contact with the friction plate, or damaged Tires.
If your lawn mower turns on but won`t move, there could be a number of potential causes. The most common issues include a broken or damaged belt, a clogged discharge chute, a broken or damaged drive cable, or a damaged or clogged transmission.
If your riding lawn mower won`t drive forward or slows down when you go uphill, check the drive belt. Reinstall the lawn tractor or riding mower drive belt if it`s slipped out of place. Replace it if it`s damaged or broken.
Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator`s manual, you`ll find a section that covers oil viscosity.
These control rods are adjustable. By rotating the threaded linkage connector ferrules, the length and the resulting range of movement at the regulator valve can be altered.
If you attempt to push a tractor with a hydrostatic transmission, it causes fluid to move backward through the pump and can damage the seals. You must disconnect the drive before moving your lawn tractor.
Riding mower not going forward or reverse could be caused by a number of issues. The most common cause is a stuck or broken clutch, which prevents the mower from moving. Other causes could include a broken or disconnected drive belt, damaged transmission, or a problem with the mower`s starter or ignition system.
If the PTO clutch is not getting power, if the clutch solenoid is defective, or if the clutch is worn out, the lawn mower blades will not engage. The PTO clutch is not repairable—if the clutch is defective, you must replace it.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : Garden

L110 bagger installation
ANSWER : I can’t help you on the bagger hole location. But you will need quality hi-lift blades. “Gator-Blades” are some of the best. At www.mowpart.com or Amazon.com

Read Full Q/A … : Garden

Hi what is the size of the deck belt for a john deere d100 rideon mower thanks
ANSWER : Visit the on-line store, know as reliable-store, they have the repair manuals. I’m sure you will get the solution of your problem.
Best Manuals

Read Full Q/A … : Garden

What size – Length belt fits L110 – John Deere L100 Series
ANSWER : Model # GX20072 is for a 42 inch deck . It fits a variety of John deere mowers

Read Full Q/A … : Garden

I have arx75 rining mower when i put it in gear it does not move when i raise the rearend up in the air the tire spin what could be wrong with it
ANSWER : Http://www.fixya.com/support/t9023324-replaced_transmission_john

Read Full Q/A … : Garden

Where is the battery located on a john deere RX73 riding lawn mower?
ANSWER : These mowers did not have electric start, therefore no battery

Read Full Q/A … : Garden

Where is the voltage regulator/rectifier located on a D130 mower?
ANSWER : Its under flywheel

Read Full Q/A … : Garden

What causes JD 260 riding mower to start dying when you engage the mower deck? It runs fine when you disengage the mower deck.
ANSWER : It’s the safety system that causes this. There is a switch under the seat that should activate when you are sitting in the seat. The switch can come loose or fail, the mounting can break, or the wires can come loose – any of these would cause the “engine dies when I engage the mower deck” behavior. Lift the seat, examine the switch. Rmove the switch and keep the plunger in with a piece of tape. Fixed? Then it’s just the mounting or adjustment. Not fixed? It’s the switch itself or the wires or connectors to it.

Read Full Q/A … : Garden