d quick attach. I was wonder what would cause this and how to fix it?
420,1020,2010,2020,2510,2520 Tractor Float

Experienced gardeners share their insights in answering this question :
First check level of hydraulic oil. Sight plastic tube just above and to the right of the hitch. Should be in the middle of the tube. How long since you changed the hydrostatic oil filter under the seat deck? Next see if the small splined shaft is turning btween the seat deck and the transaxle from the rear of the tractor. If not, it sheered a key in the hydrostatic drive shaft from the motor to the drive. (Had this happen to me)Check the lever under the right side fender that disables the hydrostatic transmission to allow the tractor to to be moved without dragging the wheels. Make sure its not in the wrong position.If all these are ok then the hydrostatic pump has failed.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Manufactured between 1984 and 1992, what made the 316 notably different from the 318 was that it had no power steering. If you`re used to the smooth steering of a higher end or later model lawn and garden tractor, the 316 can take some getting used to.
Location: Serial number plate below the steering column on the John Deere 316.
Failure of any mechanical component, a broken hose, or clogged filter will cause tractor hydrostatic transmission problems. But the most common issue will be the oil itself. In the transmission section of your operator`s manual, you`ll find a section that covers oil viscosity.
Low-Viscosity Hy-Gard replaces the John Deere All-Weather Hydrostatic Fluid and should be used as a direct replacement for all applications recommending hydrostatic fluid.
Fuel Tank 71 L (19 gal.) Base Machine 2806 kg (6,180 lb.)
Rated Operating Capacity: 795 kg (1,750 lb.) Operating Weight: 2806 kg (6,180 lb.)
As seen in the example, the model number will be displayed below the MODEL heading (Example: Z235), and the serial number will be underlined on the top-right corner of the tag (Example: 130002). If you`re looking for the engine number, that can be found directly on the engine itself.
To determine the year of manufacture for a tractor with a six digit number use the following formula. Take the first and the fourth digit, and subtract three to get the year. For example, the serial number of 395602 would be: 36-3 = 1933.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Hello,
We have a John Deere 2140 Tractor with front end loader attachment. How do we engage the PTO, or where is lever.

Thanks

ANSWER : Located between the gear lever and ratio lever on the centre console

My tractor is turned to the right and the steering wheel will not let me turn it to the left. What is it?
ANSWER : Usually a frozen kinkgpin or bent linkage.

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Ecu module Engine turns over but will not start
ANSWER : Pull plug touch block see if plug is sparking if not check safty switch to be bad jump each one until you see park at plug some swithches just unhook do not jump

Our john deere 400 is eating the belts for the front pto drive
ANSWER : Flat idler to left of belts is most likely seizing up during use.

I have arx75 rining mower when i put it in gear it does not move when i raise the rearend up in the air the tire spin what could be wrong with it
ANSWER : Http://www.fixya.com/support/t9023324-replaced_transmission_john

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.