ars . please help
2008 CR-V
Can it be so serious to buy a new gearbox as per mechanic not Honda mac? The car drives fine when gold , but after 1 km it stops.
Experienced gardeners share their insights in answering this question :
Perhaps a transmission cooler would help your problem or using the proper tranny fluid
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Low Transmission Fluid: For both manual and automatic transmissions, the primary cause for whining when in gear is low transmission fluid. If the fluid is too low, then the internal components of the transmission are not lubricated properly.
If you notice your car making a grinding sound when it accelerates, your issue is likely to do with your transmission, a problem with your differential, a bad wheel bearing, a damaged CV joint, or a worn engine/motor mount.
If your car is hesitating when you try to accelerate, then it might be time to change your fuel filter. Over time, the filter can become clogged with dirt and debris. This can make it difficult for the car to get the fuel it needs to run properly.
Owners of the model year 2007-2010 Honda CR-V also have several complaints regarding the transmission. Examples are that the transmission is faulty and the vehicle shudders in low gears, the vehicle will not shift out of park, and the vehicle stalls and accelerates and decelerates on its own.
Whining and howling
Whining that appears relatively suddenly and becomes very loud over short period of time can be indicative of damage to the gear teeth or gear hub bearings. The most likely source of this damage is a shortage of lubrication.
Should the whining noise of your transmission continue whenever your vehicle is in gear, this can mean there is a problem occurring in your torque converter. Check to see if the noise desists when you shift the vehicle to park or neutral. A constant whining noise when your car is in gear needs professional attention.
A loud noise coming from your vehicle when you accelerate, particularly one that sounds similar to a lawn mower is most likely due to an exhaust system leak.
A squeaking or squealing sound when you`re accelerating or cruising can mean there`s a problem with a drive belt on the engine. You should get this checked as soon as possible. Slapping noises when accelerating usually mean a tyre is flat or under-inflated.
The most common reasons a Honda CR-V makes noise when braking are bad brake pads, bad brake rotors, or bad brake caliper.
A humming or whining noise in an automatic transmission vehicle often means that you are low on automatic transmission fluid. If this is the case, you want to refill that fluid immediately. Transmission fluid reduces friction, which means heat, which in turn is bad news for transmissions.
Strange Noises
If the sound resembles humming, buzzing, or clunking, you may be experiencing transmission failure. Bad automatic transmissions may emit humming, buzzing, or whining noises while manual transmissions have harsher “clunking” sounds.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I have a Honda crv 2008 awd . A week ago a wining sound started from the automatic transmission box. Car only moves when cold and disengages gears . please help
ANSWER : Perhaps a transmission cooler would help your problem or using the proper tranny fluid
Wont start no ignition put new plug in and fuel filter
ANSWER : Flush gas tank, fill with fresh gas and Stabil. Replace air filter. Remove bowl from carb clean bowl and holes in bowl screw.
Have 2008 Honda CRV. New tires + balanced. 150000 miles. Had slight front end vibration when new but improved. Now vibration is much worse and needs to be addressed. Any ideas?
ANSWER : Look for loose or worn tie rod ends and deteriorated rubber suspension parts
How to reset the timing on a 6.5 HP honda – Honda GX200-RH2 22mm Shaft 2 to 1 Gear Reduction 6.5 HP Engine
ANSWER : The timing is fixed and determined by the position of flywheel on the crankshaft. If your timing is off, most likely the key holding the flywheel to the crankshaft has sheared. Remove the flywheel, inspect the key and replace if needed; reinstall the flywheel.
Honda gx200The water blaster just stopped and I change the spark plug but still only a very small spark that is when it sparks?Coil buggered?
ANSWER : Very small spark okay as long as its blue and not bright yellow.try using starting fluid if runs might want to see if carburetor is getting fuel.
How many pounds of compression is a Honda GCV190 suposed to have ?????
ANSWER : That engine has a compression release device. You will need a “leak down device” to check it. A quick check is to use your thumb over the plug hole, while someone pulls the start handle. If it forces your thumb off from the hole- it’s enough to start/run.
My Mantis Tiller won’t start and there is grinding type noise when I try and start it. I recently did some very lengthy trench digging over a period of about 2 months.
ANSWER : It sounds like the clutch springs may be overheated and the clutch shoes rub while you try to start it.If you loosten the screw that holds the engine to the gear box you can try to start it without the clutch and see if that is it.Good luck
My Honda 160cc lawn mower engine cut out when I hit a large clump of grass. Now I cannot get it to start. Has always started with no problems. What to do?
ANSWER : Has probably broken flywheel key ….. putting it out of time