or a fuel mix prob. ? Thanks a bunch
Consumer Products 9.0 Amp, 14 In. Chainsaw
Experienced gardeners share their insights in answering this question :
This is likely a long term situation that occurs with either, incorrect premix, incorrect oil being used in the premix or the motor is running too rich. The discharge over time, will clog the exhaust and the engine will become more and more difficult to start. To fix:1. Rebuild your carburetor. This is relatively easy and the cost would typically be less than $15 as a DIY.2. Tune the carburetor (especially the ‘H’ high speed jet) at wide open throttle (WOT) to get the engine to the highest RPM’s then back it off about 1/8 turn3. Replace spark plug4. Clean air filter with soap/water and lightly spray with oil.If you are unable to clean the inside of the muffler, replacement may be necessary depending how clogged it has become.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Homelite recommends using their brand of oils, specifically designed to work in any model with a 50-to-1 fuel ratio. Mix fuel at a ratio of 16-to-1, which is 8 ounces of two-cycle oil and 1 gallon of gas, and add an antioxidant fuel stabilizer, when using oil that does not contain fuel stabilizer.
The recommended fuel mixture is a 50-to-1 ratio of unleaded gasoline and two-cycle engine oil, and the manufacturer recommends the use of a two-cycle oil that contains fuel stabilizer to keep the mixture fresh if you are not using it immediately.
The year 1963 saw the introduction of the world`s first “lightweight” chainsaw, the magnesium-alloy framed Homelite XL-12; the numeral twelve denoting that the power-head weighed a mere twelve pounds. This saw is widely regarded as one of the most recognizable and well-known chainsaws of all time.
Help protect your 2-Cycle gas outdoor power equipment with the Homelite 2-Cycle oil. This oil is a 50:1 gas-to-oil ratio.
For a 50:1 ratio of gas to oil, use 2.6 fluid ounces of oil per gallon of gas.
The fuel and oil mixture should always be 2% (50:1).
Most modern chainsaws, string trimmers, leaf blowers and other small-engine two-stroke equipment recommend a 50:1 oil mix ratio, but some recommend 40:1 and older two-stroke equipment might even call for 32:1.
The XL-2 has a 1.6 cubic inch (26.2cc) engine and is avail- able with a choice of 12-inch or 14-inch capacity guide bar and chain.
HOMELITE – Techtronic Industries TTI.
Use a 32:1 gasoline to oil ratio.
Use a 32:1 gasoline to oil ratio. One gallon of gasoline combined with 4 oz of two-cycle engine oil. If you are in the state of California, use a 2-cycle oil mix ratio of 40:1.
SAE-30 Small-Engine Oil.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Homelite d3350b what is fuel oil mix i was told i could use 50 to 1 because the new oils are better?????
ANSWER : Buy a good quality oil and mix it to the OIL manufacturers recommendation regardless of what the chainsaw manual says. If you are poking around the barn and find an old can of Homelite 2 cycle oil that says mix 25:1 mix it at that ratio.
All modern oils, chainsaws, and the EPA recommend 50:1. There has been great improvement in 2 cycle technology over the years. To rich a mix causes carbon build up on the piston that breaks loose and scores the piston and cylinder, and it stinks!
All modern oils, chainsaws, and the EPA recommend 50:1. There has been great improvement in 2 cycle technology over the years. To rich a mix causes carbon build up on the piston that breaks loose and scores the piston and cylinder, and it stinks!
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
What is ment by 50 to 1 mix
ANSWER : 50 to one is a ratio of fuel to lubricating oil. Typically 50 parts petrol/gasoline to one part two stroke oil.
Oil typically comes in a special plastic bottle that incoporates a measure. Simply squeeze the right ammount of oil into the little chamber and add to 5 litres of gas.
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
Fuel oil mix,16 or 32
ANSWER : 32:1 should be it. It is better to try this and if it runs VERY smokey and fouls the plug it may be 40:1.
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
IS TRUFUEL 40:1 FUEL+OIL MIX ACCEPTABLE TO USE IN MY ELECTRIC CHAINSAW
ANSWER : What kind of joke is this?????
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
What is the oil/gas mix ratio? – Husqvarna , No.455 Rancher, 20" Gas – Powered Chainsaw
ANSWER : 50:1 ratio 2.6 fl oz of 2 stroke oil to 1 gal of fuel
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
Need fuel mixture specs – Homelite Gas, 20 In. Bar, 46 CC, Chain Saw, UT10520
ANSWER : 50:1 is the fuel to oil ratio using a modern synthetic saw oil available at home centers, hardware stores, and saw dealers. Be sure to mix the fuel and oil in it’s own container, and to shake the container thoroughly each time just before filling the tank to prevent oil starvation. Hope this helps!
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
Fuel Ratio Fuel mix ratio for Homelite (chainsaw) ut # 10520a
ANSWER : 40:1 is about right. Be sure to use modern synthetic oils made for saws and premix thoroughly before adding to the saw.
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
I need to know the proper gas oil mix for the 42cc engine
ANSWER : 50:1 is the correct fuel to oil ratio. Be sure to use a modern synthetic oil made for chain saws, and premix the fuel and oil in it’s own can– shake the can thoroughly just before filling the saw each time. With the very lean fuel to oil ratios used today, it is important to keep the oil in suspension to prevent engine damage. Hope this helps!
Read Full Q/A … : Consumer Products 9.0 Amp, 14 In. Chainsaw
