Consumer Products Backpack Blower/Vac, Carb
I have the tank replaced with new gas and the proper mix. 50:1.
Before start,I pushed the primer ball 8 times. I can see the primer
ball is now full with gas.But nothing seems going through to the
Carburator. Is somewhere plugged?
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Over time, the spark arrestor can become clogged with soot. If the spark arrestor is clogged, the engine may not start. To unclog the spark arrestor, remove it and clean it with a wire brush. You may also replace the spark arrestor.
There may be old fuel in the tank
Leftover fuel in your leaf blower is one of the primary reasons a leaf blower won`t start. Gas left in the tank for 30 days or more can deteriorate, causing the engine to stall or not start properly. If left for 6 months or more, the gasoline can turn into a thick sludge.
If your blower is having a difficult time starting, then you may be dealing with a carburetor issue. The carburetor`s job is to ensure the proper mix of fuel and air is directed to the blower`s engine. As mentioned, the carburetor can become clogged, making it difficult for fuel and air to enter the engine.
Blower motors are designed to circulate air, so they won`t work if there`s no air to move. You should always check the filters and vents surrounding the blower to make sure that the blower isn`t having a hard time working. Look into your air filter`s housing and check the markings on your filter.
If your leaf blower engine is lacking power, it could be due to a blocked air filter. A plugged air filter will restrict air flow into the engine, reducing power and performance. Changing the air filter is an easy fix, and should solve this issue.
To completely start over the game, including all challenge progress, go to Options > Misc > Hard reset. The same result can be achieved by deleting the save. dat file. This will also reset options, which you can preserve by copying options.
The engine misfires or runs rough. The engine starts, but stalls shortly after. There is a noticeable increase in fuel consumption during normal equipment use. The spark plug itself appears damaged or corroded with carbon build-up or rust.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
My 2008 chevy trailblazer doesnt want to start when I fill up with gas
Poulan gas blower 30 c back pack blower ran fine stoped will not start no spark
Check switch is bad if not coil bad if not getting spark
Homelite Leaf Blower won’t stay running
Hey .. Did you replace the inlet screen in the carb ?
Either the carburetor, block behind it, or the cylinder are loose. Common Homelite problem.
Let me know ….
Where can I find a gas cap for the Homelite HB 100
You can get a Rotory one for a Lawn mower repair shop pretty cheap
My vac wont start, there seems to be a problem with the choke not opening up properly, the spring seems to be broken?
You may have sucked some rubbish into the carb which is stopping the choke from opening properly, try taking the air filter off and having a look inside the carb to see if there is anything in there.
Hard to start. How do you prime it correctly?
Put on choke prime two or three times and the start
I just need a manual for the Homelite Mighty Lite Gas Powered Blower Vac.
Do you have your model number?
You should be able to find your manual on this site:
The manuals are listed by their model number rather than their marketing name. Look for the serial number plate which should also have the model number.
Thank you for using FixYa!
I recently tuned up my blower. It starts great but if I turn it off Nd try to restart it it floods and will not start until I let it sit for awhile.
If the engine is warm and you shut it down, leave the choke off, lower the revs and start it. (when the choke is wide open you are using the fresh air coming in to dry the spark plugs and prevent flooding). If the motor is already flooded use that procedure to dry the plugs, then go back to full choke until it tries to start and quits again, then use half choke and pull one more time… works all the time.