correct replacement part anywhere online.
It is a small, black plastic piece that is the size of a quarter and normally attaches to the governor’s lever. It has been impossible to find and correctly identify this part online.
It would be great if someone could help me identify the part number and where I can purchase it. I would like to repair it myself, if possible.
Thanks so much!
Garden
Experienced gardeners share their insights in answering this question :
Have you checked here. if you don’t recognise the part, contact them here for a call. you will get it.Regards
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
There are several reasons a Craftsman lawnmower may turn over but not start, with the most common ones including the following: Lack of fuel. Dirty air filters. Electrical issues in the ignition system or the starter motor.
Disconnected, dirty or fouled spark plugs are common causes for engines that won`t start. For small engines, spark plugs typically need to be replaced every season or after 25 hours of use. You should also check to make sure the spark plug gap is set correctly.
First, check for a blown fuse because you can usually see a blown fuse just by looking at it. The fuse on most riding mowers is connected to the small red wire that connects to the starter solenoid post. Check the fuse and replace it if it`s blown.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Your lawn mower turning over but not starting due to several reasons, such as a faulty or disconnected plug, a disconnected spark plug wire, a clogged air filter, or a contaminated fuel tank. A faulty carburetor, a dirty cutting deck, or a dysfunctional flywheel brake can also cause this.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I have a Craftsman Lawn Mower, Model No. 917.388571
It won’t start, apparently due to one small broken part. I have been unable to find the correct replacement part anywhere online.
It is a small, black plastic piece that is the size of a quarter and normally attaches to the governor’s lever. It has been impossible to find and correctly identify this part online.
It would be great if someone could help me identify the part number and where I can purchase it. I would like to repair it myself, if possible.
Thanks so much!
ANSWER : Have you checked here. if you don’t recognise the part, contact them here for a call. you will get it.Regards
Toro 149cc Lawn Mower Won't Start – Toro Lawn Mower With Toro Power Tools
ANSWER : Bad carburetor your old fuel jammed up the jet so it won’t get fuel and if it does it will start and shut off So replace the carb or try to clean the jet and run non oxy fuel only
My toro 6.5 hp push mower (2010), has no fire to the plug. I have not abused it. i have a small yard and it just gets normal use. Now it won’t fire. I first changed the fuel and cleaned the carb thinking it was that crappy ethanol again. but i grounded out the spark plug and cranked it…no spark. I think it has to do with the lever you pull back to start it . they have some stupid complicated safety contraption that rides along the fly wheel when you pull back on the handle for starting and shutting off the engine. …it looks worn out already…like a mini brake pad. any ideas?…do i really have to replace this garbage every year or am i on the wrong path here?
ANSWER : Unhook your wire from the coil that goes to shut off mechanism, and see if you have spark then. the wire may be grounded out, or your coil might have took a ****
Mower runs for about 5 min, than dies won’t restart . When cool start up ( craftsman 42 in deck 19.5 hp lawn tractor )
ANSWER : Check for spark when it dies you could have a bad coil
My 42 in Craftsman Tractor will not start. It normally runs great. I went to start it the other day and it ran for about 5 seconds before shutting down. It felt like it was getting no fuel. Any Suggestions?
ANSWER : Try and run it with the gas cap loose the vent could be plugged also see if it cuts out while keeping you foot on the brake and its just a bad safety switch shutting it off
I have trouble starting a toro walk behind mower
ANSWER : All, I thought my carb was shot, so I replaced it. Still, start but no run (and had to use starting fluid). THEN!!! I noticed the spring to the “rev limiter” (just below and towards rear of carb) was not “tight”. The stupid bracket that holds the end of that spring had been bent down ~1/16″ and that caused all this heartache. CHECK YOUR REV LIMITER!!!
<!– from fixya rte –>Rj19lm plug gap for a 195cc 4cyl lawnboy – Lawn-Boy lawnboy" Mower Blade 21"
ANSWER : As a starting point in my shop i always use 0.30 in. For all my mowers
Craftsman riding mower lt-1000 leaks gas – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
ANSWER : Need to fix that. it may be a fire hazard.
