25cc Gas Line Trimmer
Experienced gardeners share their insights in answering this question :
If you have spark problems, remove the wire and then remove the plug, reattach the wire and ground the plug to the engine and pull the string, you should see arc and hear it pop, if not, take the plug to another piece of equipment and remove that equipment’s plug wire and attach it to the plug from the weed ******* and then ground it and test it. If still no spark, then plug bad, if plug then the weed ******* has a problem with the spark plug wire or the ignition coil.If you have spark at first test, then the problem with the weed ******* is somewhere else.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Turn on the ignition switch and pull the starting cord quickly. You should see a spark in the plug gap. Since the spark may be faint, it may help to do the test in a dark area. If there is no spark, check for a broken or shorted (bare) lead wire or bad switch.
A blocked or dirty fuel filter
You need air for your initial spark – and if oxygen cannot move readily through the system you will have problems both starting and keeping your whipper snipper running. Wash the air filter in soap and hot water, then allow to air-dry.
Loss of spark is caused by anything that prevents coil voltage from jumping the electrode gap at the end of the spark plug. This includes worn, fouled or damaged spark plugs, bad plug wires or a cracked distributor cap.
Check the electric socket where you have plugged in your charger to see if it is working. You can also try plugging in a different device to make sure the power outlet is working.
The air filter may be clogged or dirty. If the air filter is clogged, the engine will get too much fuel and not enough air. As a result, the engine may stall. If the air filter is clogged, replace it.
The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the hedge trimmer. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and prevent the engine from starting.
The more worn or dirty spark plugs are, the greater the pull on the rewind and more effort is required to produce an adequate spark. If you haven`t turned on your engine recently, your mower won`t start and/or you have to tug repeatedly on the rewind to start the engine, a damaged spark plug may be the culprit.
2 stroke has fuel and spark but won`t start
You`ve confirmed that the gas is getting to the carb, and the spark plug is properly igniting, but your 2 stroke dirt bike won`t start. The most common causes are a dirty carb or low compression.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I have a craftsman 32cc weedwhacker trimmer and its brand new and it hasnt started from day one it isnt getting any spark at all
ANSWER : If you have spark problems, remove the wire and then remove the plug, reattach the wire and ground the plug to the engine and pull the string, you should see arc and hear it pop, if not, take the plug to another piece of equipment and remove that equipment’s plug wire and attach it to the plug from the weed ******* and then ground it and test it. If still no spark, then plug bad, if plug then the weed ******* has a problem with the spark plug wire or the ignition coil.If you have spark at first test, then the problem with the weed ******* is somewhere else.
Read Full Q/A … : 25cc Gas Line Trimmer
My crafsman 32cc weedeater will start when primed and choke is in start position. If i just let it run it begins to rev up and it eventually stalls. When i push the trigger it will rev up and stall. What is the problem?
ANSWER : Here is my Tip on this problem:www.fixya.com/support/r6078121-fuel_line_relacement_trimmer_weedeaterJim
Read Full Q/A … : 25cc Gas Line Trimmer
My 32cc starts right up but as soon as i give it gas it stops…help
ANSWER : The low side carburetor adjustment screw needs to be turned counter-clockwise. Start by turning it 1/4 turn then test run. If your carb has plastic locks on the screws, they will have to be removed first. Most modern carbs require a special tool to adjust the jets. The tool can usually be purchased from your local repair shop.
Read Full Q/A … : 25cc Gas Line Trimmer
I have a 32cc Craftman Brush wacker trimmer and the fuel line fell apart I need to know how to install the new ones.
ANSWER : This problem seems to be the biggest and most popular one by far in these forums and has been answered several times. Try and post your problem using the search feature on this site. Don’t use too many words. Craftsman Weedeater Fuel Lines should be sufficient. If you can’t get it, then post back here again please.
Read Full Q/A … : 25cc Gas Line Trimmer
Trimmer starts and runs for 15 seconds and stops. won’t start for a few minutes and does the same ,
ANSWER : Check the air filter, replace the fuel if it is last year’s, clean the spark plug or replace. Also lube the blade. Good luck…Lee
Read Full Q/A … : 25cc Gas Line Trimmer
Craftsman 32cc Trimmer Runs with choke at idle, then stalls
ANSWER : Sounds like somewhere you have a air leak. Most likely it’s somewhere near the carburetor intake or maybe the carb itself. Could be a line from the primer if it has one and i do believe it should that could be leaking or loose. Good luck.
Read Full Q/A … : 25cc Gas Line Trimmer
Fraftsman 32cc weedwacker starts most of the time. but will not idle
ANSWER : I took it to a repair shop.!!!!!!!!!!!!
Read Full Q/A … : 25cc Gas Line Trimmer
Will not start
ANSWER : Did you try the air filter. could be not getting air. And are you sure it is firing. if so try a spray of ether. You can but at auto parts store. but be careful with it. don’t use much. If it is firing it will go.
Read Full Q/A … : 25cc Gas Line Trimmer
