2-Cycle Tiller
Help I forgot how to start my mantis. can’t find manual yet
Experienced gardeners share their insights in answering this question :
Close the choke , pump primer bumb 3 or 4 times pull rope with the switch turned off then turn it on and pull rope again.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If there is no spark, this indicates that the spark plug is defective and should be replaced.
IMPORTANT NOTE: Using an undersized cord, a larger number cord gauge (AWG) than recommended in the chart, will cause a loss in power and overheating of the tiller.
How do I know if my mantis is adult? For most species it is easy to see if you have and adult mantis or not: adult mantises have wings while nymphs never have wings. Some species never grow wings, also not when adult, but this is rare.
If your mantis is lying on its back and doesn`t seem to be moving, it might be dying. If it`s lying on its side or front, it might be molting. If you believe your praying mantis is sick, you should keep them hydrated and provide them with a warm, humid, and dark environment.
How do I know if my mantis is adult? For most species it is easy to see if you have and adult mantis or not: adult mantises have wings while nymphs never have wings. Some species never grow wings, also not when adult, but this is rare.
The model number on a Mantis tiller can be found on a white label, located on top of the engine housing. The model number will be located at the bottom of the label in the “Item#” field. Enter the model number of your Mantis below to search for parts.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Wont start flooding – Mantis Tiller
ANSWER : Iwould start out by checking to make sure you have spark. If you do you likley have a fuel problem. have you ever replaced the carbureator or had it rebuilt?
Where is the spark plug located won't start – Mantis 4-Cycle Tiller
ANSWER : Try looking for the plug wire and follow it in. Should be coming out of the flywheel shroud on top of the engine. Good luck.
Does not run, will start with starting fluid – Mantis 2-Cycle Tiller
ANSWER : You should never use starting fluid on this model.
Add a couple of ounces of 100% acetone (available at Walmart) to some fresh fuel. Attempt to start for several pulls. Let sit for several minutes and repeat until it sounds like it wants to run.
Then watch this video and do it:
http://www.alamia.us/mantis_parts_s/148.htm
Tines continue to work with out touching safety or throttle. they engage as soon as I start the engine.
ANSWER : Remove H (high) L (low) plastic caps to allow you to further adjust the flow and you will be going. H (red) further out about 11 threads exposed and L (low) about 8 exposed; adjusting the low side will stop the tines, but remove tines before making any adjustments, thanks
Mantis tiller idle screw adjustment – Mantis 2-Cycle Tiller
ANSWER : Start out with 1.5 turns on High speed jdet and 1/2 turn on the low speed. Make sure plug is not wet, better yet install a new one. Clean, fresh fuel and give it a pull.
When I Start Mantis Tilleer it starts in gear ( tines are turning)
ANSWER : The Mantis has a speed controlled automatic clutch.
Lower the idle speed by turning the idle screw counter clockwise. The idle screw is attached where the throttle cable meet the carb. The screw has a pointed end that resembles a pencil point.
The engine speed should be adjusted just above stalling.
If the tines turn even when the engine pull rope is pulled, the the clutch is defective and needs repairing.
j
Mantis starts fine then when it warms up it stalls when you pull the throttle. Is it the carb clogged up, or do you have any sugestions?? I have replaced the gas and oil??
ANSWER : Hello. the carb is partially clogged. do this. get a bottle of carb cleaner to add to the fuel. follow the instructions on the bottle regarding the amount.
also get an aerosol can of starting fluid and a helper. start it up and have the helper spray starter fluid into the air intake as you pull the throttle. continue until the clog is cleared. joe
My Mantis Tiller won’t start and there is grinding type noise when I try and start it. I recently did some very lengthy trench digging over a period of about 2 months.
ANSWER : It sounds like the clutch springs may be overheated and the clutch shoes rub while you try to start it.If you loosten the screw that holds the engine to the gear box you can try to start it without the clutch and see if that is it.Good luck
