ILL NOT STAY TIGHT FOR A STURDY HOLD
Garden

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Screw the hanger bolts into the table legs. Fit a bolt into each leg. Turn the bolts by hand to start the installation and, once they stay in place, finish with locking pliers or an open-ended wrench. Make sure the legs feel secure, not wobbly, and won`t come out once you turn the table over.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I BOUGHT THE COFFEE TABLE MODEL MS41-021-008-32 GOT IT TOGETHER EXCEPT THE LEGS. THEY SCREWS ARE TO LONG AND GO THROUGH THE WOOD AND IT JUST WILL NOT STAY TIGHT FOR A STURDY HOLD
ANSWER :

Read Full Q/A … : Garden

Chain wont stay tight – Poulan Pro Chain Saw 46cc 20"
ANSWER : Is the chain being properly oiled? Make sure the cover fasteners are tight after adjustment. If the chain is dull or is improperly sharpened, it will heat badly causing the chain to become loose. Adjust the chain (cover fasteners finger tight) so that the chain just comes up to the lower bar, but not so tight that you can’t pull the chain by hand. Make sure the teeth cut toward you on the bottom run. Run the engine at speed with the bar tip near some cardboard for a few moments, it should throw off a thin line of oil onto the board. Hope some of this helps!

Read Full Q/A … : Garden

Wont stay running – Mtd 22" Yard Machine Push Mower
ANSWER : Under neath the carby is a single brass bolt, undo it

that one bolt is a multi jet, find four holes use a fine pin and carby cleaner ,hint one is at the top were the thread starts , one is in the inside center and two in the sides
put it back in and prim and start, hope it helps

Read Full Q/A … : Garden

Poulan pro chain wont stay running – Poulan Pro Chain Saw 46cc 20"
ANSWER : Keep “poulan” ha ha

Read Full Q/A … : Garden

Chain won’t stay tight on my poulan 222 pro. I have the correct chain size. Does the bar need to be replaced?
ANSWER : No, the bar fasteners are not tight enough. If the saw is under warranty, take it to a servicing dealer for repair or instructions to correct what you are doing wrong. Good luck!

Read Full Q/A … : Garden

How do you remove the ignition coil? I can remove the bolt quite easily, but how do you remove the post which secures the other end of the coil?
ANSWER : Would of been very helpful if you would of mentioned the engine you are working on… model/serial numbers would of been even better !!!

Read Full Q/A … : Garden

Why gas toro weedeater wont stay running – Ryobi 30 Cubic Centimeter Curved Shaft Gas Trimmer
ANSWER : The diaphragm in the carburettor is worn out.

Read Full Q/A … : Garden

Where is the primer ball
ANSWER : It may not have a primer ball. If it does, it would be attached to the carberator. If it starts, but won’t stay running, that could mean your carberator needs to be cleaned/serviced.

Read Full Q/A … : Garden