Husqvarna

Experienced gardeners share their insights in answering this question :
It’s supposed to unless it’s doing it when the belt is engaged. but you didn’t state that.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and cause the engine to run roughly.
Insert an adjustable wrench on one of the lift-link adjustment nuts behind the driver`s seat. A lift-link adjustment nut is on each side of the mower. Turning the nuts counterclockwise lowers the deck, and turning them clockwise raises the deck.
If your riding lawn mower engine dies when you release the brake, there`s a good chance the mower`s seat switch is broken or unplugged. The seat switch stops the engine when it doesn`t detect an operator sitting on the seat to prevent the mower from moving without a driver.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
For most effective results, a lawn mower deck should have a pitch, or height difference of 1/8-inch to 1/2-inch between the front of the deck to the back of the deck.
Turn the adjusting lock nut clockwise to raise the mower and counterclockwise to lower it. Measure from the blade to the ground again on both sides and adjust until the difference between the blade tip heights are within ⅛ -inch. Rotate the blades so that their direction is now front to back.
Braking Causes Car to Cut Out – Reasons

If the torque converter is broken, or if there is a low fluid level in the transmission, the converter will not do its job, and the car will be unable to maintain power at low speeds, which causes the engine to shut off.

Mower deck gauge wheels should be properly adjusted to prevent scalping grass on uneven terrain. The bottom of the wheels should sit approximately 1/8-1/2 of an inch from the ground, depending on your cutting height.
A perfectly tight mower belt can rotate without slipping off but not cause the engine to over-exert and overheat. If the belt does not slip off while working and is not producing unfavorable sounds that indicate wearing off of the belt, then that is the perfect tightness for it.
Clogged or Dirty Air Filters

It is one of the most common problems that cause lawnmowers to sputter. The mowers take the air from the surrounding through air filters and mix it with fuel inside the engine. So, if the air filter is clogged or dirty, it will affect the flow of air into the carburetor.

The mower surges when the carburetor sucks air through an unsealed gap in the air intake manifold instead of through the air filter. Dirty carburetor. Clogged fuel jets inside the carburetor commonly cause the lawn mower engine to surge. Clogged jets can`t provide the right mix of air and fuel to the engine.
Loss of power while working

If you feel loss of power while you are working with your Ride-On mower, this could be due to: Damaged belt tensioner which is tensioning the cutting deck belt. The belt connecting the cutting deck being damaged.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

What size and how many blades do I need for my husqvarna 21 hp riding mower with a 46 inch deck?
ANSWER : Well I guess laying down next to it and taking a look under the mower deck is beyond the question. One could ask about how many teeth the horse has or just look in its mouth. However, I am going to guess 3 blades as 2 blade units usually are 42″ cut maximum. Mine is 48″ and has 3 blades.

Read Full Q/A … : Husqvarna

I have located the oil drain and have the plastic tube attached. I do not see how to open the drain.
ANSWER : If it’s like mine (MTD) you push in and turn counter clockwise, should be about a full 1/2 turn, make sure you relieve the head pressure by taking the dip stick out. Hope this helps

Read Full Q/A … : Husqvarna

Can I remove dflector shield if I have a mulching kit on my22 hp 42″ cut lawn tractor?
ANSWER : Yes, you will have to put a plate off the discharge. Hope this helped Tim

Read Full Q/A … : Husqvarna

My brakes are not braking correctly, I need to know where to adjust
ANSWER : Hello eddher:

The Following is a General Instruction File I Made for this Problem. Readjust the Brake Rods to the Original Positions. Now to Adjust the Brake Pads. Tighten the Center Adjusting Nut Until SNUG. Loosen the Adjuster Nut 1/8 Turn and Try the Brakes. If Braking is Not to your Satisfaction, then Adjust the Center Adjusting Nut on the Disc Brake Assembly Slightly (1/8″ at a time) Until the Proper Braking is Achieved.
The Brake Assembly is on the Left Side of you Hydro Transaxle.
You can View the Husqvarna Model List at this Site Addy, http://www.partstree.com/parts/ and Click on the Husqvarna Logo. Now Enter the Model Numbers GTH 2448 T in the Search Box on the Left and Click Go. Now Select the Model of the Equipment you Wish to View. The GTH 2448 T 917.279260 has a Hydro transaxle Breakdown.
Please, Do Not Hesitate, If you Hit a Snag or this Does Not Correct the Problem, I am Here if You Require More Assistance. Hope this Helps. Let me Know What Happens, Please. May the All Mighty Bless You and Yours. Be Safe and Be Happy. Thanks.
Good Luck
Respectfully
jbridger (John)

Read Full Q/A … : Husqvarna

Why does the deck wiggle back and forth and scalp lawn on one side?
ANSWER : Perhaps the anti scalping wheels need adjusted or don’t lower deck so far .

Read Full Q/A … : Husqvarna

Husqvarna 460 rancher saw- chain brake is tripped and locked; cannot replace cover How do I reset the chain brake?
ANSWER : Pull back on the chain brake, this will release it.

Read Full Q/A … : Husqvarna

Have a 46 in deck need to put the belt on i forgot how it go on the deck
ANSWER : Go online to your mowers site and they should have the proper belt and pulley positions for you.

Read Full Q/A … : Husqvarna

How to unlock motor on husquavarna mower – Husqvarna Lawn Tractor 48" Deck, 23 Hp, Model# Yth2348
ANSWER : I’d love to help but don’t know what you mean by ‘unlocking’ the motor?
Jurgen

Read Full Q/A … : Husqvarna