Garden

Experienced gardeners share their insights in answering this question :
You will have to replace it thats the only way for sure if its bad or not check shops for used one possible they might have one

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Examine the plug cap for arcing and the coil wire for chafing. If damaged, it will cause an intermittent no start. Higher temperatures create higher resistance to the flow of voltage; that`s why coils usually fail when the mowers are hot and start working again when the engine cools.
Other things that could cause this issue are bad fuel, weak/colapsed/kinked fuel line, faulty spark plug, faulty ignition/coil, oil over full, clogged air filter, plugged/dirty carburetor, worn engine parts internal rings/valves/etc.
If the coil fails completely, it will leave the engine without spark, which will result in a no spark, no-start condition. Problems with ignition coils are usually easy to detect as they produce symptoms that will be quite noticeable to the driver.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
Dirty Filters and Spark Plug

If you suspect a dirty air filter, try removing it and then starting the engine. Clean or replace the filter if the engine turns over. The spark arrestor, located behind the muffler, may also be clogged. If you`re sure the air filters are clear, the spark plug may not be firing.

As the fuel level drops, a vacuum begins to form in the fuel tank because air can get in to fill the space the consumed fuel occupied. After about 10 or 15 minutes, the vacuum will become strong enough that fuel will stop flowing to the carburetor and the lawnmower will die.
A faulty or dirty spark plug could be the reason your lawn mower won`t stay running. It might produce the initial spark, but the spark won`t be enough to keep the engine running if the plug is clogged with dirt and oil. Spark plugs are usually located on the front of a push lawn mower and connected to a black cable.
If your engine misfires or stalls when you are idle or when you stop suddenly or accelerate, there could be a problem with your ignition coil. A misfire — which can sound like a coughing or sputtering noise or feel like a jerk or strong vibration — means that one of the engine`s cylinders is not firing correctly.
If you suspect the coil is dead, you can also remove the coil, plug it back in, and use an ignition spark tester like OEM 25069 to determine if the coil is firing. You can also use a multimeter to test resistance.
If the ignition coil does not have spark, it`s time to check its wires. Use a test light to check the continuity on the signal wire and power wire on the ignition coil. If both wires are functional but the coil fails to produce spark, the ignition coil or the ignition control module is bad.
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn`t work, you might need a new fuel filter.
A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the carburetor and cause the engine to stall.
If your vehicle won`t start, it`s usually caused by a dying or dead battery, loose or corroded connection cables, a bad alternator or an issue with the starter. It can be hard to determine if you`re dealing with a battery or an alternator problem. Here`s how to know which one is the culprit.
Why won`t my car start but I have power? If you attempt to start up your car but the engine won`t turn over and the dashboard lights up, then you most likely have an issue with your battery. You could have a damaged or corroded battery terminal, which is stopping the engine from starting up when you fully turn the key.
1 Start motor engages but the engine doesn`t turn

The simplest cause of this sort of fault is a loose or corroded electrical connection. If there is a fault with the internal windings of the starter motor, bad brushes, or other electrical faults, the starter motor may lack the torque to crank the engine.

Condensation inside the gas tank is one culprit, but moisture can also enter the system through a loose or ill fitting gas cap. The best solution is to drain the mower`s gas tank and refill it with fresh gasoline. A clogged fuel filter can also cause a mower engine to die.
Your lawn mower runs for 30 minutes then dies if you are having issues such as a bad spark plug, air problems, a malfunctioning carburetor, or a faulty gas cap. You may even encounter the issue that your lawn mower runs for 5 minutes then dies.
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that`s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
Excessive heat and vibration can cause the insulating material to break down and create internal coil failure. Worn secondary ignition components such as spark plugs or wires can cause a coil work harder, require more voltage, and therefore significantly reduce the operating life of the coil.
A dirty carburetor is one of the most common causes for a lawn mower not being able to start after sitting unused for months or years at a time.
An airlock is one of the common causes why your mower won`t start after running out of fuel. An Airlock occurs when air replaces fuel in the fuel lines. As you refill your fuel tank, you could push the air towards your mower`s carburetor, which keeps the new fuel from reaching the engine.
An airlock is one of the common causes why your mower won`t start after running out of fuel. An Airlock occurs when air replaces fuel in the fuel lines. As you refill your fuel tank, you could push the air towards your mower`s carburetor, which keeps the new fuel from reaching the engine.
An easy solution is to remove the mower casing and clean it of dirt and debris. Low Oil Levels can also cause overheating. With not enough oil circulating, internal friction occurs preventing heat from not being reduced. Be sure to check your oil level each time before you start your machine, and add oil if needed.
An easy solution is to remove the mower casing and clean it of dirt and debris. Low Oil Levels can also cause overheating. With not enough oil circulating, internal friction occurs preventing heat from not being reduced. Be sure to check your oil level each time before you start your machine, and add oil if needed.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Why wont my blade engage
ANSWER : Bad pto clutch shorting out

Read Full Q/A … : Garden

Wont stay running
ANSWER : Bad fuel or check for water in your fuel! Clean your carb and float bowl. Empty gas
into a clear container, if there is two levels of liquid one of them is
water. Of course make sure you have good spark plug.

Read Full Q/A … : Garden

Toro cutting off
ANSWER : Maybe low oil level, all mowers have a low oil cutoff. 30w oil.

Read Full Q/A … : Garden

Diagnosing possible pto issue – Toro Zero Turn Rider 74366 Lawn Mower Tractor Rider Ztr
ANSWER : Check plug on the pto itself.located under the mower near the rear end. contacts probably have dried dirt and mud. if that don’t work, tap it with a hammer,it may be just stuck.Thats what I did and it been working ever since. Hope this helps someone.Let me know.

Read Full Q/A … : Garden

Was mowing and the mower wouldn’t let me move forward backward left or right. I walked behind the mower and found a coil with a hook piece underneth. Bought a new coil but don’t know where it goes. Any info would b nice. Model #174164
ANSWER : Sounds like the hydro release rod, at back bott of mower, what this does is releases the hydro so you can push the mower around, then you have to release this and then your hydro works

Read Full Q/A … : Garden

<!– from fixya rte –>How do I engage bagger on zero clearance – kawasaki 48'' Toro Com Zero Turn Lawn Mower 21hp Kawasaki ()
ANSWER : That should be covered in your manual. I’m not sure what a zero clearance mower is actually, are you assuming and making up a name for it?

Read Full Q/A … : Garden

Engine runs, blades turn but mower will not move
ANSWER : Look in front of back tired on frame, not deck, there are. 2 rods, 1 on each side, rods look like a L, it’s going through a little eye opening, push it backards, mower should move. If rod is pulled through opening and locked in, mower will not move..its a safety. Feather on mower

Read Full Q/A … : Garden

Mower wont keep running – Toro Lawn Mower With Toro Power Tools
ANSWER : Recycler toro 6hp. 10 years old,little usage. Starts then stops, have to keep priming. Can anyone help?

Read Full Q/A … : Garden