Experienced gardeners share their insights in answering this question :
Go to their website. That’s what I would do….
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
The second-generation Rachio 3 Smart Sprinkler Controller is currently topping our list because it offers a ton of easy-to-use options and isn`t intimidating to install. The model we tested offers control over eight zones (sometimes called “stations”), though there`s an additional model that supports up to twice that.
The Sustainable Irrigation Program prepares, oversees and implements Land and Water Management Plans in designated irrigation areas.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Hunter node _ Running water all the time
Solenoid Valve set to manual on St Valve to off position
I have installed a Hunter psr22 pump start relay and connected it to a Hunter src irrigation controller and when I cycle the irrigation controller to manual all stations it will not start the pump. There is pump power in to and out of the relay. The pump will start when relay operated manually. There are only two wires from the relay that have been landed on the controller terminals mv and c.
So the mv and c are supplying power to the transformer/relay and out of it, but the pump won’t start until the relay is forced.
I’m thinking the relay contacts are oxidized, and need to be cleaned. When they have oxidation, current goes up, and voltage might appear ok. If any start capacitors are in the circuit, they can be faulty, breaking down under a load, while reading ok. I haven’t heard of any caps in these systems, but just in case.
The following blog may help you- it’s about different controller situations:
Hunter’s website has some things to check concerning the controller:
Looks like it could be microprocessor lockup. It’s quite a process, but here’s what they say is the fix:
Good luck, hope this helps, and thanks for using FixYa.
I want to apply scotts grub ex. With an earthway spreader, what setting should i use?
You have scot’s i want bayers grub killer
What i s setting on scotts lawn pro spreader to spread lesco momentum force weed andfeed 21-0-11
You can normally gauge it from the size of the granuals i think it is between 6 and 7
Hydro-Rain HRC-100-04-NA 4 Station Ind/Out Controller
What’s the problem?
What is spreader setting for scotts southern turf builder on my earthway ev-n.
3/4 of all the way be sure to shut off before turning as u can clump fert in grass
I have an older scotts drop spreader, called a precision flow control model and do not know what settings to use with the Scotts turf builder I have purchased.
The best way is to just place a small amount… like 5 lb in the hopper…start with it barely open and see how far you get,,, then compute from there what you need…
The settings they give you are guesamates at best and are often set to place too much… why not??? they are selling you a product!!
Irrigation valve vibrates when opening.
Yes, the diaphram can be dirty or your water pressure can be too high…try installing a ball valve in line and throttle it a bit and see if that helps. The more expensive solution should pressure be your problem is to install a PSR (Pressure Control Valve) at the main source of your irrigation water.