Ht816r Electric Hedge Trimmer Operators Manual

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the chainsaw. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and cause the engine to stall or run roughly.
The most common problem with a string trimmer is that the unit runs out of string. The string may also be twisted or loose on the spool. The cutting head may be dirty or the head outlet guide may be bent. An electric trimmer`s power cord, switch, or motor may fail.
Position a taut rope or string across the top and bottom of your hedge to establish a guideline. This will help make sure you don`t cut too much of the shrub. Slowly run the power trimmer along each side of the bush, little by little. Take frequent breaks to step back and assess the shape.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Engine running but blades dont move – Ryobi 18V Hedge Trimmer
ANSWER : If its electric/battery operated suspect stripped gears and throw it away as you tried to cut something to big with it. If its gas then suspect the same thing but it’s repairable

Trimmer head won’t turn
ANSWER : If you didn’t recently take it apart, then it sounds like you have broken the drive shaft in the neck of the trimmer. You can probably find this at an outdoor power and equipment type of store.Jim

How do I loosen the blade nut on my Ryobi 4 cycle edger? Which way does it turn??
ANSWER : Try heating the nut slightly with a gas torch and continue to turn counter clockwise as the manual suggests to undo.
The heat will expand the nut slightly making it easier to undo, don’t overheat the nut as this could damage it.
check their isn’t any locking washers holding the nut in place, bend the washer out of the locking position if this is the case.
Try using a larger spanner or extend your handle to give you maximum leverag

Ryobi strimmer petrol strimmer stalls on rev up can you solve this problem
ANSWER : I can not take the cover off to put the line back in

Hi i wonder if you can help my Ryobi hedge trimmer has a problem with the pull cord it works goes in and out but it does not turn the engine over is there maybe a key way or something that maybe broken ??
many thanks
Nick
ANSWER : Hello Nick,

Inside the cord attaches to a plastic wheel which cranks the engine. This cord can become loose or can break after some use. Try opening the plastic casing where the cord is to see if this is the problem.

Thanks

When in operation the Ryobi S430 string trimmer leaks oil continuously. How can I fix this problem?
ANSWER : Ryobi told me the unit can’t have the s430 trimmer bottom end raised higher than the engine at any time, or it will leak. Apparently they released a product to compete with other companies for cheap 4 cycle trimmers without much care for the end user.

What’s your problem, trimmer cuts out on run?
ANSWER : Sounds like fuel problems tip out all fuel clean tank add new fuel (right mix) try that. make sure choke is working and throttle. good luck.

My trimmer slows down when applied to material to cut; on its own it runs fine. its electric & feels like its going to stall when you’re cutting. what gives?
ANSWER : Take it apart and clean the slip rings and brushes