223L
Experienced gardeners share their insights in answering this question :
Ill send you the IPL
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A push/pull throttle is a dual cable throttle operation where the pull cable opens the throttle plates, while the push cable, along with a throttle return spring, closes the throttle plates. The “push” cable is a misnomer as the push cable also pulls.
To control engine speed, a mechanical governor uses gears and flyweights inside the crankcase to detect changes in the load and adjusts the throttle accordingly.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Throttle cable On a number 40 Husqvarna Chain Saw I need to replace the throttle cable. How do I access the throttle cable on the engine end?
ANSWER : This advice is not model specific, but normally you would remove the air filter and access it that way.Usually the actual fitting of the cable to the carburettor is pretty fiddly; sometimes it is easier to remove the carb, to do it.
Read Full Q/A … : 223L
353 husqvarna chain saw won’t start.
ANSWER : Did you try adjusting the throttle cable? does it start at all then die ?
Read Full Q/A … : 223L
No tnesion presnet when I squeeze the handle.
ANSWER : REPLACE THE CABLE
Read Full Q/A … : 223L
How to replace throttle cable fpr husqvarna 223 l
ANSWER : Ill send you the IPL
Read Full Q/A … : 223L
What information can you tell me about a Husqvarna chainsaw model 61 with serial number 6136460. Does it indicate the year?
ANSWER : Most of the CDI modules have been superseded to part no# 544018401check with your local dealer to verify.
Read Full Q/A … : 223L
Gas trigger jams and does not depress fully on a husqvarna 345. The unit is 9yrs. old.
ANSWER : Check for wear on the plastic end of the throttle push rod, if so it tends to catch where it comes out of the fuel tank, replace if worn.
Read Full Q/A … : 223L
Husqvarna 240 want start at all – Husqvarna Chain Saw 18" 450 Model 966955438
ANSWER : Sounds like the ignition module or spark plug. The ignition module is what controls the spark plug that gives your saw the firing capabilities. Before you purchase one of those, replace the spark plug and see if that works. The 240 is a newer husqvarna; so I am skeptical to say it is the ignition module. However, any new product can have a bad part on it. Your saw may have gotten flooded and won’t start. Make sure your gas mixture is 50/50 gas to mixing oil. Always use fresh gas. If you make up gas and don’t use a whole gallon at a time, put some fuel stabilizer in the mixture; so it will still be fresh the next time you use it.
Read Full Q/A … : 223L
How do you install primer bulb on husqvarna 125b blower, which line to hook up where
ANSWER : Hello . After you replace the primer bulb , the left tube on the primer bulb goes to the fuel filter inside the tank and the one on the right is just a fuel return that goes inside the tank . Hope this help
Read Full Q/A … : 223L
