TB146 EC 4-Cycle Garden Cultivator
Both gas lines are broken. How do you replace the broken lines
Experienced gardeners share their insights in answering this question :
Hi Robert:
Sounds like a matter of removing the old lines and installing new ones.
Work safe! Drain fuel from tank first.
Sounds like a matter of removing the old lines and installing new ones.
Work safe! Drain fuel from tank first.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
First, start the cultivator. With the tines off the ground, squeeze the throttle control to engage the engine. Then, holding the handlebar firmly with both hands, slowly lower the cultivator down until the tines contact the ground. As the tines dig in, pull back on the cultivator to penetrate the ground.
For a tiller with a bladed wheel, push the tiller forward while it`s in the ground. This will rotate the blades and till the soil. For a tiller without the wheel, twist the tiller as you pull it straight out of the ground.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
I replaced old gas lines and now gas pores out of carburator,switched the lines to other end of carburator and now it pores out of muffler
ANSWER : Ok, this sounds like problems with the float valve in the carburrettor float chamber. This will mean the you’ll have to dismantle the carburrettor, do you feel competent to do this?
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
I need to replace to fuel lines on a Craftman 32cc trimmer. The old ones cracked apart. 2 of the lines look like 1/8″ OD one line looks like 3/32″ OD. Larger line looks like it hooks to filter, Smaller line to a fitting in the gas tank. I am assuming the smaller line ges to the primer inlet. My question is the lines penetrate the bottom of the gas tank. How do they seal. How do I install the filter and the fitting. I am assuming to thread the new lines in from the bottom of the tank and pull through the gas cap hole. Then I attach filter or fitting and pull back through. So do I pull the line so as to create a seal from the swell caused by the fitting/filter?
ANSWER : Depending on the brand of line you use, Tygon line is self sealing but seems to shrink faster then factory supplied because of the ethanol in the gas. The stone gas filter is designed to fall to the lowest part of the tank, not stop the line from falling out.
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
Gas line routing – Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
ANSWER : Try going to a local hardware store and ask them about gas routing for chainsaws. If that doesnt work then I suggest to send the chainsaw back and have them replace it.
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
Need to replace fuel lines on my Troy Bilt gas hedge trimmer. Where can I get replacement fuel lines… or better yet… what size are the lines and where can I buy a few feet of the lines. Note: I have reviewed the parts assembly and it would seem to indicate I have to replace the entire handle assembly (Part #1) instead of just buying replacement hose(s). Any help to resolve my issue would be greatly appreciated and thanks in advance
ANSWER : Replacement fuel lines should be readily available at your local lawnmower repair shop. Your TroyBilt hedger uses fuel line that is 3/32″ (2.4mm) interior dimension, 3/16″ (4.8mm) outside dimension, with a 3/64″ (1.2mm) wall dimension.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.
Most manufacturers don’t offer replacement line, only fuel tank assemblies. Find your local shop, and try to get the TYGON brand…it is yellow. Tygon lasts the longest. You should be able to buy it by the foot for less than $2 per foot. You will need 2 feet of hose to replace both lines.
Make sure to clean the in-tank filter when replacing hoses.
Good luck.
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
Need to change gas line tube – Craftsman Convertible 25cc. Gas Line Trimmer
ANSWER :
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
Fuel line diagram for craftsman gas blower – Craftsman 25cc Gas Line Trimmer
ANSWER :
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
The fuel lines have rotted out of the edger gas tank. How do I fix or do I need to replace entire tank with new fuel lines?Since there are no male fuel line connections exiting the fuel tank and just two holes where the lines were, I guess I need to replace the entire tank and get a new one with lines already attached. Thanks.
ANSWER : No you can buy replacement fuel line but you must reconnect the filter in the tank that line goes to the bottom of the carby then out the top of the carby to the inlet on the primer then out of the primer and back to the tank.
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
Try to replace 2 gas lines that from the craftsman gas line trimmer, but forgot how to put them back…any manual availabel?
ANSWER : Can you show me a diagram?
Read Full Q/A … : TB146 EC 4-Cycle Garden Cultivator
