I have a flat tire on my tractor and the valve stem is behind the tire therefore I have to remove the tire to get to the tube
Experienced gardeners share their insights in answering this question :
If you can’t get to the valve stem (from either side, it sounds like you have bigger problems than just getting the tire off. It sounds like you will need to break down the tire to reseat the tube in the proper placement.Some mowers have studs and nuts like a car, and others use a cotter key and washer to hold it on (which is probably what you have since you had to ask how to remove the tire). The cotter key and washer is under a cap that just pulls off. You can use a small screw driver to work it out.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Tractor rear tyre size in India
The most common tractor rear tyre sizes are 12.4-28,13.6-28,14.9-28 and 16.9-28.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
How do u remove the tire off a rear rotiller – Troy Bilt Mtd Tiller Wheel Tire 480×4008
Remove the pin that secures the wheel to the axle and remove the wheel. Sometimes the wheel will become rusted to the axle and can not be removed. Its best to leave it be. Attempting to beat the wheel off the axle runs the risk of causing internal damage to the transmission. Once the wheel is off, remove the valve and release the air then using your tire tools remove the tire.
Removing the rear tire to repair a flat. i don’t know how to get the plastic cover off the axle shaft to get to the axle nut
Pull off the rubber cap. Make a tool by bending a piece of wire or preferably metal and pull the cap towards you until it slides off.
How do I remove the clutch on an Echo chain saw??
Backwards to the rotation of the motor, all you need are basic tools to do this.
Change rear wheels on self propelled lawn mower
Unbolt wheel or re move hub cap or a nut cover pull of the retaining clip remove wheel reinstall in revers with new wheel retainig clip if bolt just tighten up
Replace rear wheel bearing 773 bobcat
You must unbolt it from inside chainbox. Raise cab, and remove about 8 bolts that hold a plate that is back toward the engine, in line with back axle. Inside you will see 2 large chains and sprockets, and a bolt that holds the sprocket to axle. Use a 1-1/8″ wrench to remove bolt, then axle may be removed. Replacing outer bearing and seal is now possible
The back tire is flat and i need to change it
In most cases you will find the the bead leaks and needs to be cleaned then it will seal
Flat tire its an older model. i got the front tire off. i just had to pop the pin out. the two back tires though, i cant get them off! I took out the bolt in the center of the rim (i believe i used a 13mm socket). I thought it should pull off but i cant get it. Do i need to keep banging on it til it gets loose. Its been sitting for a while. there is some rust
I find the when they are stuck that bad you will break more by trying i pop of the beads with a pry bar and just change the tires right on the machine keep in mind if the outside has rust the wheel where the tire seals will as well if so put in a tube it will save you time later
Removing tire from SEARS CRAFTSMAN LT1000 TRACTOR.
You need to remove the black rubber cap from the center of the wheel. Remove the “C” clip from the axle and the wheel should come off. The rear tires will have a square key in it. Do not loose the key.