Rear flap has cracked on both sides, leaving some of the grass clippings to bypass catcher and fly out the sides of flap
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Lawnmowers. The model name can be found on the “Housing Decal” located on the lawmower deck, below the rear flap. The lawnmower model and serial number can be found behind the engine on the lawnmower deck.
Just as the back flap is important to ensure objects don`t fly out the rear of the mower, the throw guard on the side of the mower can keep objects from flying out the side and damaging property, people, or pets.
Rear skirt 532416860 attaches to the mower deck to protect your feet and legs from grass clippings and debris.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Change rear wheels on self propelled lawn mower
Unbolt wheel or re move hub cap or a nut cover pull of the retaining clip remove wheel reinstall in revers with new wheel retainig clip if bolt just tighten up
I have had a poulan pro 550 series push mower for almost 1 year at the end of the season last year the mower would start briefly and then stop. i have cleaned out the air filter and that did not help.the mower started, i made one revolution around the yard 3/4th of the way the mower quit. I then primed the mower it started then quit and now it will not start at all. Does anyone have any suggestions of what to do. Thanks
There is a little spring that works the carburetor arm. If that popped off then the mower will not run.
Lawn mower cranck but wont start…
Since you already checked for spark and air I would drain all the fuel out of it and check that fuel for water. Over time some lawn mowers end up with contaminated fuel. You can see the water sitting on the bottom of the fuel if you let it stand for a bit in a small plastic bowl.
Be sure to empty and dry out you fuel can as well. Especially if the mower stopped running right after a refuel. Which is a good sign your gas can is contaminated too.
Cannot remove mower blade pulley nut – John Deere 22HP VTwin 48" Riding Mower
I think its a left hand thread, you undo it clockwise (the “wrong” way)
I’ve been trying to start my briggs & straton Masport lawn mower, after it was sitting idel for over a year.
Replaced oil ok / added new fuel / spark working, however it dies after fisrt kick over.
have i forgotten about a cut out switch somewhere?
am i using too much / too little throttle?
what else should i check?
I had the same problem. It turned out to be a blocked carby and the way to fix is as follows;- remove air filter- start mower (assuming it now starts)- place open hand over carby hole and then remove. The force of the spinning blades will **** through the blockage.You may need to prime it first.Hope that helps.
<!– from fixya rte –>Pull cord on masport mower seized – ProMow Lawn Mower. Sport Field 7-Gang Pull-Behind Reel Mower
Maybe the engine is seized ???
Where is oil drain plug on MTD mower – Mtd LAWN MOWER PART # 683-04163B FRAME Assembly:RIDER
If it isn’t on the bottom of the engine (above the blade) then you don’t have one. This is not that uncommon. When you need to drain the oil, FIRST- pull the spark plug wire off!!! Then remove the dip stick or filler plug and turn the unit upside down and drain the oil.
How do u remove the tire off a rear rotiller – Troy Bilt Mtd Tiller Wheel Tire 480×4008
Remove the pin that secures the wheel to the axle and remove the wheel. Sometimes the wheel will become rusted to the axle and can not be removed. Its best to leave it be. Attempting to beat the wheel off the axle runs the risk of causing internal damage to the transmission. Once the wheel is off, remove the valve and release the air then using your tire tools remove the tire.