Experienced gardeners share their insights in answering this question :
Hello sir, Please provide the following information so that your issue may be diagnosed properly,what is it? brand name,complete model number The problem, What is happening with what? When it is happening? Are there times it does not happen? Did it just start happening? Did it ever work ? Did any seemingly unrelated event coincide with whatever it is not working? need the model number and brand name, if you need a manual i need the brand name and model number,if it is a riding mower the model number is under the seat.a snow blower the model number is on the rear of the machine, let me know,thank you. “
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
CRAFTSMAN String Trimmer Line, 0.065- Inch, 3-Pack Spools, 30 Foot (CMZST0653), Red.
1 Remove the cap on the trimmer. 2 Take out the spool. 3 Remove the previous string. 4 Insert the new wire into the spool.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Fraftsman 32cc weedwacker starts most of the time. but will not idle
I took it to a repair shop.!!!!!!!!!!!!
My 32cc weedwacker starts up fine on full choke, move slowly to 1/2 and it will run strong for a couple seconds and then just shuts off. It does this over and over.
First, check the fuel lines for cracks/breaks.If they are o.k.,
then you will need to disassemble the carburetor and spray with carb.
cleaner. Make sure the small screen in the carb. is free of debris. Use
a Den Tek Brush, (http://www.drugstore.com/products/prod.asp?pid=165357&catid=1152), to clean the small portals in carb. Reassemble and start.(NOTE: If the cleaning doesn’t work, then buy a carb. kit abd replace all appropriate parts.)If you need further assistance, just let me know.Jim
Problem with primer bulb
Reverse the line connections at the primer bulb. Look carefully, the long port has the line going to the tank, the short port on the bulb will connect with the fuel line to the carb.
I have a 32cc Craftman Brush wacker trimmer and the fuel line fell apart I need to know how to install the new ones.
This problem seems to be the biggest and most popular one by far in these forums and has been answered several times. Try and post your problem using the search feature on this site. Don’t use too many words. Craftsman Weedeater Fuel Lines should be sufficient. If you can’t get it, then post back here again please.
How do you change a craftsman 32cc weedwacker gas filter in the gas tank?
I used a long pair of tweesers to grab the filter, but you can also grab it with a piece of wire with a hook bent on the end of it large enough to fit the tubing the filter is inserted into.
Hook the filter tubing, and pull the filter to the top of the tank and manuver it out of the tank.
Please take time to rate me
My crafsman 32cc weedeater will start when primed and choke is in start position. If i just let it run it begins to rev up and it eventually stalls. When i push the trigger it will rev up and stall. What is the problem?
Here is my Tip on this problem:www.fixya.com/support/r6078121-fuel_line_relacement_trimmer_weedeaterJim
Craftsman 32cc Trimmer Runs with choke at idle, then stalls
Sounds like somewhere you have a air leak. Most likely it’s somewhere near the carburetor intake or maybe the carb itself. Could be a line from the primer if it has one and i do believe it should that could be leaking or loose. Good luck.
The gap for weed wacker
THE GAP FOR THIS IS 0.30THS