Garden

Briggs & stratton
Experienced gardeners share their insights in answering this question :
First you must get a new pimer bulb kit ,,,, then at the base of the pimer bulb their is a ring,,, grab the ring with finger tips or a pair a plyers and twist counter clock wise it will unscrew take the ring off and the bulb will come out and replace with new kit

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Placement should be considered first. The filter should be installed in the outlet line that delivers fuel to the engine, after the tank outlet fitting but before any fuel pumps, regulators, primers or primer bulbs, or other filters.
There are different types of gasoline primer bulbs, all of which contain various types of valves inside. Sometimes these bulbs become so hard it`s difficult to squeeze them; sometimes even though you can squeeze them, they pump poorly, if at all.
Marine fuel primer bulbs are available in three sizes for 1/4″, 5/16″ and 3/8″ inch fuel hoses.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Need to replace primer bulb and fuel lines, is there a digram that shows the connections?
ANSWER : Http://www.ereplacementparts.com/images/fuel_line_diagram.jpg

Read Full Q/A … : Garden

Why won’t the Prime bulb fill on blower and how to fix?
ANSWER : YOU HAVE THE PRIMER BULB HOOK UP WRONG TRY CHANGING THE FUEL LINES

Read Full Q/A … : Garden

How do you replace primer bulb on ryobi chainsaw
ANSWER : Https://www.youtube.com/results?search_query=Ryobi+18%22+Chain+Saw+primer+replacement

Ryobi 18 Chain Saw primer replacement YouTube

Read Full Q/A … : Garden

No gas enters the priming bulb no matter how many times you pump it, why?
ANSWER : Three possibilities here…..clogged or gummed up fuel filter in inlet line in tank ….clogged inlet line or trash in carb on inlet lines or passages…or leaky primer bulb….I’d tear down the carb and give it a good cleaning and check the other lines just to be sure !!! If you go into the carb be sure to check the fuel metering needle to be sure it is not stuck or gummed up…hope this helps… ;-D

Read Full Q/A … : Garden

What else should i try
ANSWER : Make sure lines are connected correctly. On the back of primer it is stamped In & out

Read Full Q/A … : Garden

After about third pump bulb stays in it’s my neighbors line trimer i replaced the gas line. it was not there. i think i ran the line right.
ANSWER : Check out this sketch.

Read Full Q/A … : Garden

PUMPING THE PRIMER BULB DOES NOT WORK . HAVE RPLACED BULB AND FUEL LINES. NO SUCTION
ANSWER : The check valves in the plastic pump housing under the primer bulb are bad. Usually caused by cleaning with carb and choke cleaner. The part is available from any echo dealer. Most shops have a junk box full of them,, just ask

Read Full Q/A … : Garden

Looses prime i have replaced all the hoses and primer button and replaced the diaphrahms in the carburator. but i still hear air when i pump the primer bulb. any other ideas ??
ANSWER : Have you replaced the primer bulb ‘base’.?

Read Full Q/A … : Garden