Garden
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If the carburetor is new or has been rebuilt, you should set it to “factory” adjustment. You can do so by adjusting the idle mixture screws to 1.5-2 turns out, and the idle speed screw to 1-1.5 turns in. Warm the Engine Up. The engine`s running temperature directly correlates with proper air and fuel mixtures.
RedMax 95 octane fuel is mixed at 50:1 with a high-quality synthetic oil blend, specifically formulated to provide RedMax handheld products with optimal equipment performance. This ethanol-free fuel mix does not degrade or oxidize like pump gas and will stay fresh for years in storage.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Auto feed doesn’t work
ANSWER : Take the end apart and make sure the line is not getting bound up or is not over filled to where it can not move freely
Read Full Q/A … : Garden
Can not get spool head apart to change line, tried pump pliers, pipe wrench, won’t unscrew!!
ANSWER : If you are sure that it screws on it may be a reverse threaded unit..
Read Full Q/A … : Garden
Need to know how to wind trimmer line on trimmer
ANSWER : Depends on the trimmer, all heads are different. However, the majority of trimmers are wound as follows:
1. pop the top cover off the head, pull the spool out. It will be either single or double lined, they will be wound counter clock wise.
2. the end of each line goes out each of the seperate holes
3. slide spool back on and replace cover
www.ButlerPower.com
Read Full Q/A … : Garden
How to sharpen stihl gas power trimmer
ANSWER : Sharpen with a flat file. Its a long process as each tooth has 2 cutting edges. There are companies that will do this properly at cost.
Read Full Q/A … : Garden
How do you sharpen the hedge trimmer. It is the homelite handy hedge 2.7 17 inch blade
ANSWER : DREMEL STONE WORKS THE BEST. THEY SUGGEST TO REPLACE BLADES
Read Full Q/A … : Garden
Have a hedgetrimmer 123hd60 will start but when you give it gas to go cuts off
ANSWER : Sounds like a fuel starvation issue, check and clean carb.
Read Full Q/A … : Garden
My trimmer slows down when applied to material to cut; on its own it runs fine. its electric & feels like its going to stall when you’re cutting. what gives?
ANSWER : Take it apart and clean the slip rings and brushes
Read Full Q/A … : Garden
My hedge trimmer will not start… Put in new gas
ANSWER : It’s not getting gas, due to being gummed up with old gas. Remove all of the old gas and mix up a batch of fresh gas&oil. Also get some carb cleaner. Put just a little of the gas&oil mix plus an equal part carb cleaner. Try to start it just to work the new mixture through the carb. You might use the spray start to help pull the new gas through. If it fires up on the new gas&oil&carbcleaner mix, shut it off and let it sit for an hour or two. Drain it out and try just a little gas&oiil without the carb cleaner. If all is well fill the tank. If not, repeat the whole process. If you can’t clear the gum this way you may have to remove the carb to clean it.
Good luck.
Good luck.
Read Full Q/A … : Garden
