Garden

Model/020382 3300psi
Experienced gardeners share their insights in answering this question :
Hopefully anti-seize compound was used on the shaft of the engine when the pump was installed at the factory(most pumps will slip on either 3/4 or 1 inch shaft with key way). After you remove the four mounting bolts from the engine, the pump will slide off the shaft (most all do not lock the hollow pump mount to the shaft with set screw). Most likely you will need to work it off. Apply wd40 or Liquid wrench and allow some time for it to do its magic. If the pump is really stuck or rusted on the shaft, use metal wedges on both opposite sides between the pump and engine. Use caution when forcing the pump off because side plate of engine is not that strong. Good luck

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If the pump is leaking, the cause may be minor and easy to repair. Check the seals, packings, and O-rings for wear. These can easily be replaced, saving you the cost of a new pump. However, major leaks such as the ones caused by cracked or damaged plungers, can lead to pump failures.
Often times, a machine producing low pressure will surge, cycle on and off, or continue to run. This typically indicates that the machine is losing pressure somewhere, such as a leak in one of the lines or inside the case of the machine.
In nearly all instances, pump failure is the result of improper installation or operation rather than normal wear. One of the most common causes of pump failure is improper or unnecessary service, often as a result of the operator attempting the service.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Looking for information on a John Deere tractor S/N CH0850S017329 and the current estimated value of this tractor with approximately 2,700 hours on it.
ANSWER : Can you please post the model number of the tractor? Thanks

Read Full Q/A … : Garden

How do i replace a clutch on a JD 3020 tractor
ANSWER : Break it in half, then get with it.

Read Full Q/A … : Garden

What type of oil doe it use – John Deere Gx75 Rx75 Srx75 Sx75 130 9hp Starter
ANSWER : 10W-30 Turf Gard

http://www.greenpartstore.com/John-Deere-GF-3-10W30-Turf-Gard-4-Cycle-Motor-Oil-Quart-TY22029.html

Read Full Q/A … : Garden

Free belt diagram john deere freedom 42 – John Deere 42 in. EZ Trak Bagger
ANSWER :

Read Full Q/A … : Garden

My john deere z425 start fine but does not move
ANSWER : Check drive pulleys and belts.

Read Full Q/A … : Garden

Which way do i install thermatate in john deere 4020
ANSWER : Looking at stat top part looks like a handle around it

Read Full Q/A … : Garden

Our john deere 400 is eating the belts for the front pto drive
ANSWER : Flat idler to left of belts is most likely seizing up during use.

Read Full Q/A … : Garden

My Tractor (425) won't start – John Deere 420,1020,2010,2020,2510,2520 Tractor Float
ANSWER : If you have no spark the first thing to replace the time delay module on the left rear side of engine. Its black and about 2 inches by 1 inch with yellow,red,orange and black wires going to it. Replacement is round shaped with same amount of wires.If no fuel to carb check for flow at filter, if theres flow but no pressure look for a split fuel line in tank between pump and sender.

Read Full Q/A … : Garden