Garden
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
A single fuel pipe runs from the tank, under the floor of the car to a mechanical pump on the engine. The pump delivers fuel to the carburettor. Whenever you check fuel pipes, disconnect the battery to prevent stray sparks igniting petrol or petrol vapour.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
How do the fuel lines in a weedeater trimmer pe550 hook up inside the gas tank
ANSWER : I have an older model that has a weighted filter in the tank. The filter flops around and can ‘fall’ into the fuel no matter which way you tilt the trimmer/tank. You should have one in your tank. Feed in the new line and make the end come out the gas cap. Push the filter/weight into the end of the fuel line. Pull the extra fuel line out of the tank to match the original position. You should have cut the new line to approximately the proper or same length as the old fuel line with an angle cut so you could push it into the tank.
Read Full Q/A … : Garden
Gas line routing – Poulan Wild Thing 2375 18" Gas Chain Saw 2.5 Cuin
ANSWER : Try going to a local hardware store and ask them about gas routing for chainsaws. If that doesnt work then I suggest to send the chainsaw back and have them replace it.
Read Full Q/A … : Garden
Is it straight gas or mixed? – Poulan Pro 14" Gas Chainsaw 33CC P3314
ANSWER : It uses a gas/oil mix. 40:1Hope this helps.
Read Full Q/A … : Garden
I need to replace to fuel lines on a Craftman 32cc trimmer. The old ones cracked apart. 2 of the lines look like 1/8″ OD one line looks like 3/32″ OD. Larger line looks like it hooks to filter, Smaller line to a fitting in the gas tank. I am assuming the smaller line ges to the primer inlet. My question is the lines penetrate the bottom of the gas tank. How do they seal. How do I install the filter and the fitting. I am assuming to thread the new lines in from the bottom of the tank and pull through the gas cap hole. Then I attach filter or fitting and pull back through. So do I pull the line so as to create a seal from the swell caused by the fitting/filter?
ANSWER : Depending on the brand of line you use, Tygon line is self sealing but seems to shrink faster then factory supplied because of the ethanol in the gas. The stone gas filter is designed to fall to the lowest part of the tank, not stop the line from falling out.
Read Full Q/A … : Garden
Can not get spool head apart to change line, tried pump pliers, pipe wrench, won’t unscrew!!
ANSWER : If you are sure that it screws on it may be a reverse threaded unit..
Read Full Q/A … : Garden
How do I replace the fuel line for a Poulan ppbp30?
ANSWER : Open the top of the machine to access the carb, Normally it is easily done with needle nose pliers.
Read Full Q/A … : Garden
I have a Poulan BVM200VS (a year old) and it does not seem to be getting fuel. When I remove the gas cap and push the primer button, gas flows back into the tank via one of the lines. The other line has a filter on it. This thing is one year old.
ANSWER : Have a look at these tips for problems with blower:http://www.fixya.com/support/r9884834-leaf_blower_start
Read Full Q/A … : Garden
Gas leaking out of center hole on gas cap sears weed trimmer 358795150
ANSWER : I had same problem and got a replacement cap at a small engine shop. Seems there is a baffle in the cap to allow the tank to vent and to close off to prevent fuel leaking. Appears rubber baffle deteriorates over time.
Read Full Q/A … : Garden
