Mighty Lite Lawn Trimmer

Experienced gardeners share their insights in answering this question :
The large knob at the bottom of the spool is reverse threads, lefty loosey righty tighty is backwards for the line trimmers. I usually use a set of channel locks to grip the knob to turn it RIGHT to loosen.

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

If you decide to run a longer trimmer line, you need to completely remove the guard. If you only remove the blade, the trimmer line will get too long and get wrapped up in the guard. As the string wraps around the guard it increases the resistance on the engine and causes the engine to lose its power and RPMs.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

I cant remove the spool to change the line. it appears to be stuck.
ANSWER : Well there is either a screw knob that must be unscrewed first, or you aren’t removing it correctly. Some just Pull/pop right off. Others must be pushed in and twisted (Like a child proof cap) usually in the opposite direction the line spins. Pull the cord a tiny bit to see which way it spins, then push down/in on the spool (its spring loaded) and twist opposite. Most of today’s trimmers will give you the spool like that. Putting it back on it simply the reverse action.

Read Full Q/A … : Mighty Lite Lawn Trimmer

Need to change gas line tube – Craftsman Convertible 25cc. Gas Line Trimmer
ANSWER :

Read Full Q/A … : Mighty Lite Lawn Trimmer

How do you replace the line on the spool? – Husqvarna Forest & Garden 125l 18" Gas Trimmer
ANSWER : WHERE DO I BUY BOTTEM CASEING FOR SPOOL

Read Full Q/A … : Mighty Lite Lawn Trimmer

I need to replace to fuel lines on a Craftman 32cc trimmer. The old ones cracked apart. 2 of the lines look like 1/8″ OD one line looks like 3/32″ OD. Larger line looks like it hooks to filter, Smaller line to a fitting in the gas tank. I am assuming the smaller line ges to the primer inlet. My question is the lines penetrate the bottom of the gas tank. How do they seal. How do I install the filter and the fitting. I am assuming to thread the new lines in from the bottom of the tank and pull through the gas cap hole. Then I attach filter or fitting and pull back through. So do I pull the line so as to create a seal from the swell caused by the fitting/filter?
ANSWER : Depending on the brand of line you use, Tygon line is self sealing but seems to shrink faster then factory supplied because of the ethanol in the gas. The stone gas filter is designed to fall to the lowest part of the tank, not stop the line from falling out.

Read Full Q/A … : Mighty Lite Lawn Trimmer

Line always breaks when restringing??? line holes do not align??
ANSWER :

Read Full Q/A … : Mighty Lite Lawn Trimmer

RLT-5030AH LINE TRIMMER HOW TO PUT LINE ON SPOOL?
ANSWER : You need to prepare two lines of the same length. Wind the bottom one first. place the end of the line in the slot provided. Wind the second spool and place the line in the opposite slot. feed the lines through the two holes provided, be careful to allow the lines freedom. Insert the spool checking to see that the lines do not get pinched. You are now ready to GO!

Read Full Q/A … : Mighty Lite Lawn Trimmer

Fuel line diagram for craftsman gas blower – Craftsman 25cc Gas Line Trimmer
ANSWER :

Read Full Q/A … : Mighty Lite Lawn Trimmer

Craftsman trimmer #358791820 spool ran out and cant reload it?
ANSWER :

Read Full Q/A … : Mighty Lite Lawn Trimmer