Garden

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

How to change Inner Tubes and Tires
  1. If your moving dolly got a flat tire you will first remove the tire. …
  2. Then use either a bicycle tire pry levers or couple of flat screwdrivers to remove the tire. …
  3. Remove the punctured inner tube.
  4. Replace damaged inner tube. …
  5. Replace the tire with mounted inner tube.
18 sept. 2015
  1. Turn off the vehicle. Be sure the vehicle is on level ground. …
  2. Set your wheel chocks. Use wheel chocks around the tires that you aren`t working on.
  3. Loosen the lug nuts. …
  4. Place a jack. …
  5. Raise the vehicle. …
  6. Remove the nuts. …
  7. Remove the tire and wheel. …
  8. Put on the new wheel and tire.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Flat tire its an older model. i got the front tire off. i just had to pop the pin out. the two back tires though, i cant get them off! I took out the bolt in the center of the rim (i believe i used a 13mm socket). I thought it should pull off but i cant get it. Do i need to keep banging on it til it gets loose. Its been sitting for a while. there is some rust
ANSWER : I find the when they are stuck that bad you will break more by trying i pop of the beads with a pry bar and just change the tires right on the machine keep in mind if the outside has rust the wheel where the tire seals will as well if so put in a tube it will save you time later

Read Full Q/A … : Garden

The back tire is flat and i need to change it
ANSWER : In most cases you will find the the bead leaks and needs to be cleaned then it will seal

Read Full Q/A … : Garden

How do you remove the ignition coil? I can remove the bolt quite easily, but how do you remove the post which secures the other end of the coil?
ANSWER : Would of been very helpful if you would of mentioned the engine you are working on… model/serial numbers would of been even better !!!

Read Full Q/A … : Garden

Flat right reat tire. Cant get a jack under to lift tire off ground to take it off. Can’t lift front enough to get block under that might raise rear after lowering front. How’s it supposed to come offr?
ANSWER : Hello there, the Toro 52″ 27hp z master has an Exclusive Toro Z Stand on 27 hp (20.1 kw) models provides an on-board
tool to simply elevate the front end of the machine and provide access
to the underside of the deck.this Z stand gives access to the underside of the unit to enable you insert a jack under to change the rear tire.Here is a link to help you download the service manual, operator manual, parts catalog and setup instructions. These give more insight as regards getting the tire changed.Hope this support has been helpful?Thank you for visiting FixYa.

Read Full Q/A … : Garden

Craftsman lt1100 17.5 ohv engine won’t start without help. Starter won’t spin engine. Battery is new and fully charged. It tries to spin the engine but engine won’t continue to turn over unless I manually spin the top of the engine with my hand. Then it starts right up. I changed out the cables, solenoid with no help. Suspected the starter, took it apart. Brushes are in good condition. Cleaned, lubed it and reinstalled. Same problem. It is like the intial compression stroke is stopping the engine from turning over. New Starter????? Any help would be appreciated!
ANSWER : Try to make sure all connections are clean. i have this same machine that does exactly what you are saying. if battery is all charged up. try setting parking brake.Put in neutral, get off the machine and turn the key. this is what i do and machine cranks fast and starts. my issue is in that saftey switch in my seat.

Read Full Q/A … : Garden

The deck on my Craftsman mower is touching the ground on the left side. Help!
ANSWER : IF THIS IS WHAT I THINK IT IS .. IT’S A EASY FIX.. YOU HAVE LOW AIR PRESSURE IN ONE OR ALL OF YOUR TIRES..

Read Full Q/A … : Garden

Got a craftsman mower 42 inch deck changed spindles and blades and deck still shakes belt may not be tightening up
ANSWER : Did you put the blades on right ??? they have a star pattern and it needs to be lined up correctly… if that’s ok does the belt have a bad spot in it or is the engagement mechanism operating correctly ???

Read Full Q/A … : Garden

I need a new engine for my lawn mower (MTD)
The model “no” is 124802,,
type =0610-01
code =94062259
Where can I buy one from ? ,,I live WA PERTH
ANSWER : Call 1-800-873-6722 and give them the model and type number. I can tell you, this is going to be a lot more expensive than just buying a new mower.

Read Full Q/A … : Garden