4 Cycle Blower/Vac

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

Sometimes, when your starter rope will not retract into your leaf blower, it can be because it is jammed between the pulley and the housing, or it is wrapped around the hub. In this case, you will often be able to fix the symptom by simply opening the machine and untangling or removing the rope from where it is stuck.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Poulan gas blower 30 c back pack blower ran fine stoped will not start no spark
ANSWER : Check switch is bad if not coil bad if not getting spark

Read Full Q/A … : 4 Cycle Blower/Vac

I was replacing pull cord and the tiny bar which connects the trigger to the carb fell off before I could see how it was installed. I canot figure out how it goes back. It is a Bvm 200 25cc Poulan leaf blower
ANSWER : It should be pretty simple to replace. Would expect the trigger to come out, put the rod/bar on the carb then on the trigger (probably has to swivel the trigger to get the part on) the set trigger back in it’s position. Hope this helps. Easier to do than explain.

Read Full Q/A … : 4 Cycle Blower/Vac

Poulan leaf blower no start
ANSWER : Switch is a continuous open switchSwitch is a continuous open switch No not the switch (has been disconnected)

Read Full Q/A … : 4 Cycle Blower/Vac

What is the compression on a poulan leaf blower?
ANSWER : 60 to 70 psi it will start fine. I fix Poulan blowers every day for a living
they are very easy to fix. A common problem is stuck piston ring.

Read Full Q/A … : 4 Cycle Blower/Vac

Pull cord is difficult to pull after third pull becomes stuck but will turn if pull hard repeats every three to four pulls.
ANSWER : No response to clarification request.

Read Full Q/A … : 4 Cycle Blower/Vac

I am not getting a spark
ANSWER : No spark can be a bad switch *(need to go in and unplug it from the ignition module and retest) or your ignition module has given up the ghost.

Get a t-handle set and go online and look up the parts. A module might cost more than a new unit….I think we both know what that means! Be safe and good luck!

Read Full Q/A … : 4 Cycle Blower/Vac

Can't pull starter cord – Poulan Pro Super Blowervacuum
ANSWER : Here are some suggestions: Rope is bound on the pulley. Engine is locked up. Debris in the impeller housing. Flooded, excessive fuel in the combustion chamber. These are just a few. Hope it gets you in the right direction.

Read Full Q/A … : 4 Cycle Blower/Vac

How do I replace the fuel line for a Poulan ppbp30?
ANSWER : Open the top of the machine to access the carb, Normally it is easily done with needle nose pliers.

Read Full Q/A … : 4 Cycle Blower/Vac

My name is June Strandberg, and I am a florist and gardener in San Francisco. I have been working in the industry for five years, and I love helping people find the perfect floral arrangement for their special occasions. I am also skilled in troubleshooting and fixing gardening tools, so if you are ever having trouble with your tools, please don't hesitate to reach out to me.