Sears
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Locate the primer bulb on your blower. Look at the blower from the rear operating position. The bulb is on the left side of the rear housing between the air filter cover and the engine.
ANSWER: The primer bulb, which is located in the fuel line between the gas tank and the engine, is used to fill the carburetor with fuel when the engine is started cold. The rubber bulb resembles an oblong ball.
Placement should be considered first. The filter should be installed in the outlet line that delivers fuel to the engine, after the tank outlet fitting but before any fuel pumps, regulators, primers or primer bulbs, or other filters.
The primer bulb is generally placed close to the engine, and usually downstream of any fuel filters or water-separtors. Many new engines are delivered without a fuel disconnect fitting, and instead just provide a short stub of fuel line from the engine cowling. This makes a natural place to connect a primer bulb.
ANSWER: The primer bulb, which is located in the fuel line between the gas tank and the engine, is used to fill the carburetor with fuel when the engine is started cold. The rubber bulb resembles an oblong ball.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
How do you replace primer bulb on ryobi chainsaw
ANSWER : Https://www.youtube.com/results?search_query=Ryobi+18%22+Chain+Saw+primer+replacement
Ryobi 18 Chain Saw primer replacement YouTube
Read Full Q/A … : Sears
What else should i try
ANSWER : Make sure lines are connected correctly. On the back of primer it is stamped In & out
Read Full Q/A … : Sears
Why won’t the Prime bulb fill on blower and how to fix?
ANSWER : YOU HAVE THE PRIMER BULB HOOK UP WRONG TRY CHANGING THE FUEL LINES
Read Full Q/A … : Sears
Need to replace primer bulb and fuel lines, is there a digram that shows the connections?
ANSWER : Http://www.ereplacementparts.com/images/fuel_line_diagram.jpg
Read Full Q/A … : Sears
Troybilt trimmer primer bulb collapses. it will start occasionally but will only run a few minutes.i have replaced the primer bulb and gas lines and still have the same problems.
ANSWER : It should have a small vent in the fule tank cap if its blocked the primer bulb will be sucked in as the fule pump can **** any fule from the tank
check the tank cap first,,,,,
check the tank cap first,,,,,
Read Full Q/A … : Sears
Would like to know what year this tiller would be.
ANSWER : Replace primer bulb. If that’s not the problem check the float in the carb for pin holes . check fuel lines and intake line
Read Full Q/A … : Sears
Toro model number 200065 won’t start. New gas, new spark plug, cleaned air filter. Doesn’t feel like fuel is in the primer bulb when I prime it.
ANSWER : Some toro primer bulbs don’t fill up with fuel but blow air into a chamber in the carb that has fuel in it so when you press the bulb, the air sprays fuel into the carb ( just a little) So since it won’t start, the bulb probably has a very small crack in it. replace it and then try it.
Read Full Q/A … : Sears
After about third pump bulb stays in it’s my neighbors line trimer i replaced the gas line. it was not there. i think i ran the line right.
ANSWER : Check out this sketch.
Read Full Q/A … : Sears
