Experienced gardeners share their insights in answering this question :
Go to Sears parts web site and get instructions in the manual for your model number.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
If the cogged belt is worn out, misadjusted, or broken, the snowblower auger won`t turn. Inspect the cogged belt to determine if it is broken or worn out, and ensure that the belt is properly adjusted. If the belt is broken or worn out, replace it.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
Mtd 31c won't stay running? – MTD Genuine Factory Parts Auger Belt for One-stage Snowblower
You probably have to take the carburetor apart and clean it using a spray type carburetor cleaner spraying the jets and small holes in it.
Auger will not engage – Craftsman 26" 208cc* Dual-Stage Snowblower
Check tension on the belts
check for broken belt
I have a toro ccr 2450 snowblower. i bought it
No if your belt is shredding there is something rubbing on the belt. Check the idler/tightner pulley see if it spins freely. Check make sure nothing but the pulleys are touching the belt when it is engaged.
I need the belt diagram for a 42″ craftsman 20.5 hydro tractor
Do a model search on www.partsdirect.com. This is the website for Sears equipment. Just reminder you will need the model number from under the seat to help you find the right model.
Mower belt diagram – Craftsman 17.5 hp 42 in. Deck Lawn Tractor – CA Model
You can get a belt diagram from
just follow the leads, and have your model number handy, you will need it.
you can also get this from ayp.com
One side of auger working – Craftsman Snow Blower / Snowblower Bottom Cover :
If one side works and one side does not I would suggest There is a broken shear pin in the one side that doesn’t work. The pin is likely through the auger and goes through the drive shaft. Sounds like it could be missing.
Put new belt on for 2nd stage still does not work augers work
Sounds like roll pin has broken that is on it. Look for a hole where pin slides through shaft. Use a hammer and punch to push out broken piece out. Make sure outer hole matches up with inner hole.
Will not through snow more than 3 feet
Never knew any that would have to do it in stages when it’s too deep .