Garden

How to Identify and Fix Common Gardening Problems ?

We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :

To start the process, locate the manual fuel pump primer on the engine. This may be a small lever you pump up and down, or a plunger-type you push in. Open up the bleed screw on top of the secondary fuel filter, and start pumping the primer pump. You will likely see both fuel and bubbles coming out of the bleed screw.
Prime the fuel system by turning the ignition on (Run position) for 30 seconds, but do not start the engine. This allows the pump to prime the system. Turn the ignition off, and then crank it for 15 seconds. If it does not start, repeat the first task and this one until it starts (cycle the key).
Bleeding the low pressure side prevents, among other things, defects to the high pressure pump which can occur during filter change without manual bleeding, for example. Diesel fuel provides the sole lubrication within the system. That is why it is particularly important that it never runs dry.
When air bubbles or vapor are present in your diesel fuel delivery system, fuel injection is delayed. This delay happens because the fuel cannot be injected until the air and vapor are compressed to the correct fuel injection pressure.
When you change a diesel fuel filter, run out of fuel or disturb the fuel system, air is trapped. When you try to start the engine this air acts as a lock, preventing the normal supply of fuel into the cylinder.
When you run low on diesel, your fuel pump might send air through your fuel system instead of gas. If that happens, your vehicle will shut down and not restart until the air is removed. This is called “bleeding” the fuel system, and depending on your machine, it can take several hours to complete.
Empty the Tank

On older diesels, nine times out of 10 the process of draining the tank, flushing the lines and starting over with fresh diesel rectifies the situation. By older diesels, we mean engines that made use of lower injection pressure and looser tolerances—primarily those with pre-common-rail fuel systems.

Ammonia. Ammonia is one of the most effective ways to get rid of a diesel smell. Ammonia is an alkaline compound that neutralizes acids in diesel fuel to prevent corrosion. It also has very strong cleaning properties and will help neutralize any diesel residue on your clothes.
Explanation: Bleeding of the fuel system: Bleeding is the process by which air, which is present in the fuel system, is removed by using a priming pump.
When you run low on diesel, your fuel pump might send air through your fuel system instead of gas. If that happens, your vehicle will shut down and not restart until the air is removed. This is called “bleeding” the fuel system, and depending on your machine, it can take several hours to complete.

Discover Relevant Questions and Answers for Your Specific Issue

the most relevant questions and answers related to your specific issue

Engine runs, blades turn but mower will not move
ANSWER : Look in front of back tired on frame, not deck, there are. 2 rods, 1 on each side, rods look like a L, it’s going through a little eye opening, push it backards, mower should move. If rod is pulled through opening and locked in, mower will not move..its a safety. Feather on mower

Read Full Q/A … : Garden

Toro cutting off
ANSWER : Maybe low oil level, all mowers have a low oil cutoff. 30w oil.

Read Full Q/A … : Garden

Diagnosing possible pto issue – Toro Zero Turn Rider 74366 Lawn Mower Tractor Rider Ztr
ANSWER : Check plug on the pto itself.located under the mower near the rear end. contacts probably have dried dirt and mud. if that don’t work, tap it with a hammer,it may be just stuck.Thats what I did and it been working ever since. Hope this helps someone.Let me know.

Read Full Q/A … : Garden

<!– from fixya rte –>How do I engage bagger on zero clearance – kawasaki 48'' Toro Com Zero Turn Lawn Mower 21hp Kawasaki ()
ANSWER : That should be covered in your manual. I’m not sure what a zero clearance mower is actually, are you assuming and making up a name for it?

Read Full Q/A … : Garden

Blowing oil out of the engine – Toro 52" 27hp Z Master Zero Turn Lawn Mower
ANSWER : Check oil level fuel could have flooded through into the engine oil which will cause it to blow out if so clean out carby and check that needle in the carby is sealing

Read Full Q/A … : Garden

Exmark 44 Mower bogs down going forward
ANSWER : When you say ‘going forwaed’, is that while mowing or does it do it without the blades engaged or ‘not mowing’?

Read Full Q/A … : Garden

Battery goes dead over night – Toro 42'' Zero Turn Lawn Mower Trailer Package Deal ()
ANSWER : First thing to do is find out if it’s the battery or the mower. Disconnect the battery and leave it overnight. If it’s dead in the morning, you need a new battery. If not, you either have a charging problem (not likely if the battery isn’t dead after using the mower) or you have a current drain.

Read Full Q/A … : Garden

Oil Filter Removal
ANSWER : Oil filter removal is counterclockwise when viewing the filter from the top. Filter install is clockwise. If this is a original filter, then it will be very tight. Before installing new filter, ensure that you place a bit of new oil on the seal located on the flat portion of the new filter before reinstalling to ensure it is sealed, and it also only needs to be hand tight.

Reply if you have questions!

Chip

Read Full Q/A … : Garden