Stihl
Experienced gardeners share their insights in answering this question :
If it doesnt have a flow screw.u dont. pull pump plate off and clean and sometimes replace pump.
How to Identify and Fix Common Gardening Problems ?
We provide a variety of viewpoints on how to identify and fix common gardening problems. Our sources include academic articles, blog posts, and personal essays from experienced gardeners :
Locate the oil adjuster screw on the bottom of the chainsaw. Turning this screw will adjust the oil feed rate. Turn the screw clockwise to increase the oil feed. Turn the screw counterclockwise to decrease the oil feed.
Adjusting the L screw clockwise can cause the chain to engage while the saw is idling. Adjusting the H screw clockwise increases the maximum speed of the engine and can cause damage to your saw`s engine if its operating capacity is exceeded.
Discover Relevant Questions and Answers for Your Specific Issue
the most relevant questions and answers related to your specific issue
My 290 isn’t oiling chain. I tried adjusting oil flow and still no oil?
ANSWER : You have to remove the bar and clean it out
Read Full Q/A … : Stihl
How do I repair the oiler on my stihl chain saw model 028
ANSWER : You have to remove the little white gear to be able to get to the screws to remove it.
Read Full Q/A … : Stihl
How to adjust chainsaw oiler on stihl MS230
ANSWER : You cant. the oiler on an Ms230 is preset and non adjustable. Make sure the oil worm gear isnt damaged
Read Full Q/A … : Stihl
Ms290 oiler tube is leaking( looks nicked) just past where it comes out of the oiler tank. What is the procedure to replace it
ANSWER : There is a special puller too that STIHL dealers posess, you cannot get one, sorry, you have to pay to remove it. The good news is, there is a chinese company on eBay that sells the pumps for $6 shipped from china versus the $33 you’d pay from STIHL for the same chinese-made part.
Read Full Q/A … : Stihl
How to replace chain adjuster pin on a stihl chainsaw
ANSWER : What model saw.?
Read Full Q/A … : Stihl
I HAVE AN O17 STIHL CHAIN SAW AND IT LEAKS CHAIN OIL
EVEN WHEN IT IS NOT BEING USED
EVEN WHEN IT IS NOT BEING USED
ANSWER : That can happen. When you go to store it, open the oil cap and then close it to lose the pressure the pump builds up inside.
Read Full Q/A … : Stihl
To much oil comes out of the chain oiler – Poulan Pro 42CC 2 Cycle Chainsaw, 18"
ANSWER : Look for an oil volume adjustment screw located near the lower chain run, but on the main case rear or maybe underneath the case in the same area. Turn the screw CW to decrease flow. Remove the bar and chain to make sure the small oil passages in the drive end of the bar are not plugged. When everything is back together, run the saw tip near some cardboard at speed for a moment or two. It should throw off a thin line of oil onto the board. Hope this helps!
Read Full Q/A … : Stihl
When motor is running I have no chain drive when trigger is pressed.
ANSWER : Check and see if clutch is working or chain is adjusted too tight.
Read Full Q/A … : Stihl
